HX424C12PB2K4/16 16GB (4GB 512M x 64-Bit x 4 pcs.) DDR4-2400 CL12 288-Pin DIMM SPECIFICATIONS CL(IDD) 15 cycles Row Cycle Time (tRCmin) 46.5ns(min.) Refresh to Active/Refresh Command Time (tRFCmin) 260ns(min.) Row Active Time (tRASmin) 33ns(min.) Maximum Operating Power TBD W* UL Rating 94 V - 0 Operating Temperature 0o C to +85o C Storage Temperature -55o C to +100o C *Power will vary depending on the SDRAM used. DESCRIPTION FEATURES HyperX HX424C12PB2K4/16 is a kit of four 512M x 64-bit (4GB) DDR4-2400 CL12 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 512M x 8-bit FBGA components per module. Each module kit supports Intel(R) Extreme Memory Profiles (Intel(R) XMP) 2.0 . Total kit capacity is 16GB. Each module has been tested to run at DDR4-2400 at a low latency timing of 12-13-13 at 1.35V. The SPDs are programmed to JEDEC standard latency DDR4-2133 timing of 15-15-15 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows: * Power Supply: VDD=1.2V Typical * VDDQ = 1.2V Typical * VPP - 2.5V Typical * VDDSPD=2.2V to 3.6V * Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals * Low-power auto self refresh (LPASR) * Data bus inversion (DBI) for data bus * On-die VREFDQ generation and calibration * Single-rank * On-board I2 serial presence-detect (SPD) EEPROM XMP TIMING PARAMETERS * * * JEDEC: DDR4-2133 CL15-15-15 @1.2V XMP Profile #1: DDR4-2400 CL12-13-13 @1.35V XMP Profile #2: DDR4-2133 CL13-13-13 @1.2V * 16 internal banks; 4 groups of 4 banks each * Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS) * Selectable BC4 or BL8 on-the-fly (OTF) * Fly-by topology * Terminated control command and address bus * Height 2.167" (55.05mm), w/heatsink Continued >> kingston.com/hyperx Document No. 4807180-001.B00 04/21/15 Page 1 continued HyperX MODULE WITH HEAT SPREADER 8.12 mm 55.05 mm 133.35 mm MODULE DIMENSIONS 133.35 129.55 31.25 2.10 0.15 Pin 1 Detail A 3.35 Detail B Pin 35 Pin 47 Detail D Detail E 64.60 28.90 14.60 17.60 8.00 11.00 2.700.15 3.00 Detail C Pin 105 Pin 117 56.10 22.95 FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components. kingston.com/hyperx Document No. 4807180-001.B00 Page 2