11mm x 1.4mm BACKLIGHT ATTENTION OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES AA1114/2PBC/CC BLUE Description Features LOW POWER CONSUMPTION. The Blue source color devices are made with InGaN IDEAL FOR BACKLIGHTING. on SiC Light Emitting Diode. RoHS COMPLIANT. Static electricity and surge damage the LEDS. It is recommended to use a wrist band or anti-electrostatic glove when handling the LEDs. All devices, equipment and machinery must be electrically grounded. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAA9551 REV NO: V.3 DATE: MAR/05/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201001465 Selection Guide Part No. Dice AA1114/2PBC/CC Iv (mcd) @ 20mA Lens Type BLUE (InGaN) Viewing Angle Min. Typ. 2 1/2 18 50 120 WATER CLEAR Note: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device peak Peak Wavelength Blue D Dominant Wavelength 1/2 Typ. Max. Units Test Conditions 468 nm IF=20mA Blue 470 nm IF=20mA Spectral Line Half-width Blue 25 nm IF=20mA C Capacitance Blue 65 pF VF=0V;f=1MHz VF Forward Voltage Blue 3.65 4.2 V IF=20mA IR Reverse Current Blue 10 uA VR = 5V Absolute Maximum Ratings at TA=25C Parameter Blue Units Power dissipation 102 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating/Storage Temperature -40C To +85C Lead Solder Temperature [2] 260C For 3 Seconds Lead Solder Temperature [3] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAA9551 REV NO: V.3 DATE: MAR/05/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201001465 Blue AA1114/2PBC/CC Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength) , the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAA9551 REV NO: V.3 DATE: MAR/05/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201001465