Memory Module Specifications KVR21R15D4/16 16GB 2Rx4 2G x 72-Bit PC4-2133 CL15 Registered w/Parity 288-Pin DIMM DESCRIPTION ValueRAM's KVR21R15D4/16 is a 2G x 72-bit (16GB) DDR4-2133 CL15 SDRAM (Synchronous DRAM) registered w/ parity, 2Rx4, ECC, memory module, based on thirty-six 1G x 4-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR4-2133 timing of 15-15-15 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows: SPECIFICATIONS CL(IDD) 15 cycles Row Cycle Time (tRCmin) 47.05ns(min.) Refresh to Active/Refresh Command Time 1x mode (tRFCmin) 260ns(min.) Row Active Time (tRASmin) 33.00ns(min.) Maximum Operating Power 4.30 W* UL Rating 94 V - 0 Operating Temperature 0o C to +85o C Storage Temperature -55o C to +100o C FEATURES *Power will vary depending on the SDRAM used. * * * * * * * * * * * * * * * * * * * Power Supply: VDD=1.2V (1.14V to 1.26V) VDDQ = 1.2V (1.14V to 1.26V) VPP - 2.5V (2.375V to 2.75V) VDDSPD=2.25V to 2.75V Functionality and operations comply with the DDR4 SDRAM datasheet 16 internal banks Bank Grouping is applied, and CAS to CAS latency (tCCD_L, tCCD_S) for the banks in the same or different bank group accesses are available Data transfer rates: PC4-2133, PC4-1866, PC4-1600 Bi-Directional Differential Data Strobe 8 bit pre-fetch Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop) Supports ECC error correction and detection On-Die Termination (ODT) Temperature sensor with integrated SPD This product is in compliance with the RoHS directive. Per DRAM Addressability is supported Internal Vref DQ level generation is available Write CRC is supported at all speed grades CA parity (Command/Address Parity) mode is supported Continued >> kingston.com Document No. VALUERAM1447-001.C00 02/24/15 Page 1 MODULE DIMENSIONS Front Back kingston.com Document No. VALUERAM1447-001.C00 Page 2