MATERIALS BODY BRASS NICKEL PLATED CONTACT SILVER PLATED INSULATOR PTFE BODY NUT GASKET _ INSULATOR | ] a CONTACT = CLAMP ASSEMBLY PROCEDURES 1. SLIDE CLAMP NUT, WASHER & GASKET OVER CABLE. STRIP CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF BRAID TO PERMIT ASSEMBLY OF CLAMP. WASHER 620 | [aS i 2. SLIDE BRAID CLAMP OVER BRAID & SEAT AGAINST CABLE. FORM BRAID OVER CLAMP NUT. TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC & CENTER CONDUCTOR TO DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR -330 (8.38mm) 3. SLIDE INSULATOR AGAINST THE BRAID CLAMP. SOLDER CONTACT TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER. DO NOT OVER HEAT DIELECTRIC. INSERT CABLE ASSEMBLY INTO BODY & TIGHTEN. .220 (5.59mm) INSULATOR BODY CONTACT SOLDER MOUNTING HOLE 475 .000 .828 (21.03mm) 1.830 (46.48mm) .128 (3.25mm) 00-28 UNEF-2A <a} .200 MAX ESTABLISHED 1972 PASTERNACK ENTERPRISES PASTERNACK ENTERPRISES, INC. P.O BOX 16759, IRVINE, CA 92623 PHONE (949) 261-1920 FAX (949) 261-7451 WEB ADDRESS: www.pasternack.com E-MAIL ADDRESS: sales@pasternack.com COAXIAL & FIBER OPTICS DWG TITLE PE44093 DES. SHV JACK BULKHEAD, CLAMP ATTACHMENT FOR RG174, RG188 & RG316 REV.A FSCM NO. 53919 CAD FILE 081908 SCALE N/A SIZE A| 127 NOTES: 3. DIMENSIONS ARE IN INCHES. 1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME.