80001153214 - 3M - Datasheet.Live

Interconnect Solutions

http://www.3M.com/interconnects/

3M is a trademark of 3M Company.

For technical, sales or ordering information call

800-225-5373

3M™ Round, Jacketed, Flat Cable

.050″ 26 AWG Stranded, Mass-Term, PVC/PVC 3758 Series

TS-2200-02

Sheet 1 of 2

• Round construction permits easier routing

• 26 AWG wire on .050 inch centers permits

mass termination to broad line of IDC connectors

• Continuous bond and continuous split/bond

allows for mass termination of IDC connectors

• Meets external wiring requirements of National

Electrical Code, Article 725 (CL2)

• Primary cable is zippable for branching or

discrete terminations

• UL listed for USA and Canadian markets

• See Regulatory Information Appendix (RIA)

for chemical compliance information

(RIA E1 & C1 apply)

Date Modified: March 13, 2007

Physical

Jacket Material: Polyvinyl Chloride ( PVC )

Jacket Color: Black

Primary Material: Polyvinyl Chloride ( PVC )

Primary Color: Gray

Marking Standard: (UL) CL2 75C 26 AWG OR AWM 20267 3M NU AWM IIA/B 80C 300V FT1 EU <50V

Conductors: 26 AWG, 7× 34 AWG [7× Ø 0.160]

Inner Wrap: Polyester Film

Electrical

Voltage Rating: USA: N.E.C. 725, CL2 or AWM; 300V Canada: 300V EU: <50V

Insulation Resistance: (Primary Cable) > 1 × 1010 Ω/10 ft. [ 3m ]

Unbalanced Balanced

Characteristic Impedance: 90 Ω133 Ω

Capacitance:16.7 pF/ft [ 54.8 pF/m ] 11.9 pF/ft [ 39.0 pF/m ]

Inductance: 0.14 μH/ft [ 0.46 μH/m ] 0.21 μH/ft [ 0.69 μH/m ]

Propagation Delay: 1.50 ns/ft [ 4.92 ns/m ] 1.58 μH/ft [ 5.18 μH/m ]

Velocity of Propagation: 68% 64%

Note: Unbalanced is measured between ground-signal-ground conductors. Balanced is measured between conductors within a pair.

Environmental

Temperature Rating: USA: CL2; 75°C or AWM; -20°C to + 80°C Canada: 80°C

Flammability Rating: USA: N.E.C. 725, CL2 Canada: FT1

UL File No.: E118773, Power Limited Circuit Cable: CL 2 (or AWM) Style: 20267

Interconnect Solutions

http://www.3M.com/interconnects/

3M is a trademark of 3M Company.

For technical, sales or ordering information call

800-225-5373

3M™ Round, Jacketed, Flat Cable

.050″ 26 AWG Stranded, Mass-Term, PVC/PVC 3758 Series

Number of

Conductors

3M Part

Number

Diameter A ± 0.03 Dimension B

(See Note 2)

09 3758/09 0.26 [ 6.6 ] 0.40 [ 10.2 ]

10 3758/10 0.26 [ 6.6 ] 0.45 [ 11.4 ]

14 3758/14 0.27 [ 6.9 ] 0.65 [ 16.5 ]

15 3758/15 0.27 [ 6.9 ] 0.70 [ 17.8 ]

16 3758/16 0.27 [ 6.9 ] 0.75 [ 19.1 ]

20 3758/20 0.30 [ 7.6 ] 0.95 [ 24.1 ]

24 3758/24 0.33 [ 8.4 ] 1.15 [ 29.2 ]

25 3758/25 0.33 [ 8.4 ] 1.20 [ 30.5 ]

26 3758/26 0.33 [ 8.4 ] 1.25 [ 31.8 ]

30 3758/30 0.37 [ 9.4 ] 1.45 [ 36.8 ]

34 3758/34 0.37 [ 9.4 ] 1.65 [ 41.9 ]

36 3758/36 0.39 [ 9.9 ] 1.75 [ 44.5 ]

37 3758/37 0.39 [ 9.9 ] 1.80 [ 45.7 ]

40 3758/40 0.39 [ 9.9 ] 1.95 [ 49.5 ]

50 3758/50 0.44 [ 11.2 ] 2.45 [ 62.2 ]

60 3758/60 0.47 [ 11.9 ] 2.95 [ 74.9 ]

64 3758/64 0.50 [ 12.7 ] 3.15 [ 80.0 ]

TS-2200-02

Sheet 2 of 2

Notes:

1. Red marking on one edge of primary cable designates wire #1.

2. Dimension B pertains to bonded area only.

Notes:

3. Contact 3M for availability of additional conductor counts and/or availability

of custom roll lengths.

Inch

[mm]

±.010

±.1 ±.05

Tolerance Unless Noted

.0 .00 .000

Inch

[ ] Dimensions for

Reference only

Ordering Information

Number of Conductors

(See Table)

3758/XX XX 275 XX

Blank = Standard, Repeating Split/Bonded Wires

SO = Continuous Bonded Wire (No Split)

Length of Roll in Feet

275 = 275 ft Standard

Blank = Standard

SF = Splice Free

"A"O

Polyester Film

Paper [Mfg

Optional]

2.40

61.0 TYP

.050

1.27 TYP

26 AWG, 7 X 34 AWG [7X Ø 0.160]

PVC Primary Insulation

0.026 [0.66] Min.

PVC Jacket

Thickness

1.00

25.4

BONDED

SPLIT

"B"

Regulatory Information Appendix

3M Electronic Solutions Division/Interconnect

EUROPE

Appendix E1: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product is RoHS Compliant 2005/95/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in

excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/

EC, unless the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this

information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E2: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC

This product contains lead in the compliant pin area in excess of the maximum concentration value allowed but is

compliant by exemption under EU Commission Decision 2005/747/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in

excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/

EC, unless the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this

information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E3: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment as

amended by Commission Decision 2005/618/EC.

This product contains lead in the solder tail area in excess of the maximum concentration value allowed.

Unless otherwise stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon

information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E4: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product contains decaBDE in the insulating material in excess of the maximum concentration value allowed but is

compliant by exemption under EU Commission Decision 2005/17/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in

excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision

2005/618/EC, unless the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in

writing, this information represents 3M’s best knowledge and belief based upon information provided by third party

suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

RIA-2217-B

CHINA

Appendix C1: China RoHS

Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits

for Certain Hazardous Substances in Electronic Information Products.

This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006,

means that the product or part does not contain any of the following substances in excess of the following maximum

concentration values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium,

polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless otherwise

stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon information provided by

third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix C2: China RoHS

Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits

for Certain Hazardous Substances in Electronic Information Products.

This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006,

means that the product or part does contain a substance, as detailed in the chart below, in excess of the following

maximum concentration values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent

chromium, polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless

otherwise stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon information

provided by third party suppliers to 3M.

The numerical reference in the symbol above should not be construed as a representation regarding the product’s life or an

extension of a product warranty. The product warranty is stated below. In the event any product is proven not to conform

with 3M’s Regulatory Information Appendix, then 3M’s entire liability and Buyer’s exclusive remedy will be in

accordance with the product Warranty stated below.

Important Notice

All statements, technical information, and recommendations related to 3M’s products are based on information believed to be reliable, but the

accuracy or completeness is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended

application. You assume all risks and liability associated with such use. Any statements related to the product which are not contained in 3M’s

current publications, or any contrary statements contained on your purchase order shall have no force or effect unless expressly agreed upon, in

writing, by an authorized officer of 3M.

Warranty; Limited Remedy; Limited Liability.

This product will be free from defects in material and manufacture for a period of one (1) year from the time of purchase. 3M MAKES NO OTHER

WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A

PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your exclusive remedy shall be, at 3M’s option, to

replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be liable for any

indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of the legal theory asserted.

Electronic Solutions Division

6801 River Place Blvd.

Austin, TX 78726-9000

800/225-5373

www.3M.com/interconnects RIA-2217-B

Name and Content of Hazardous Substances or Elements