SPECIFICATION
MODEL
DCVOLTAGE
RATEDCURRENT
RATEDPOWER
OUTPUT
LINEREGULATION
LOADREGULATION
SETUP,RISETIME Note.7
HOLDUP TIME (Typ.)
VOLTAGERANGE Note.5
FREQUENCY RANGE
POWERFACTOR (Typ.)
EFFICIENCY (Typ.)
ACCURRENT (Typ.)
INPUT
INRUSHCURRENT(Typ.)
LEAKAGECURRENT
SAFETY STANDARDS Note.6
WORKINGTEMP.
WORKINGHUMIDITY
STORAGETEMP.,HUMIDITY
TEMP.COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVERCURRENT Note.4
OVERVOLTAGE
OVERTEMPERATURE
12V
7.2~12V
15V
9~15V
20V
12~20V
24V
14.4~24V
30V
18~30V
36V
21.6~36V
48V
28.8~48V
5A 4A 3A 2.5A 2A 1.67A 1.25A
60W 60W 60W 60W 60W 60.12W 60W
150mVp-p 150mVp-p 150mVp-p 150mVp-p 200mVp-p 250mVp-p 250mVp-p
¡Ó
4.0%
¡Ó
4.0%
¡Ó
4.0%
¡Ó
4.0%
¡Ó
4.0%
¡Ó
4.0%
¡Ó
4.0%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
2.0%
¡Ó
1.5%
¡Ó
1.0%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
¡Ó
0.5%
1000ms,80ms/115VACatfullload1000ms,80ms/230VAC
16ms/230VAC16ms/115VACatfullload
90~305VAC127~431VDC
47~63Hz
PF>0.97/115VAC,PF>0.95/230VAC,PF>0.92/277VACatfullload(Pleasereferto"PowerFactorCharacteristic"curve)
86% 87% 88% 89% 90% 90% 90%
COLDSTART 75A/230VAC
<0.75mA /240VAC
95~108%
Protectiontype:Constantcurrentlimiting,recoversautomaticallyafterfaultconditionisremoved
-40~+70 (Referto"DeratingCurve")
¢J
20~95%RH non-condensing
-40~+80 ,10~95%RH
¢J
¡Ó
0.03%/ (0~50 )
¢J ¢J
10~500Hz,5G12min./1cycle,periodfor72min.eachalongX, Y,Zaxes
396.7Khrsmin.MIL-HDBK-217F(25 )
¢J
162.5*43*32mm(L*W*H)
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Constant current operation region is within 60% ~100% rated output voltage. This is the suitable operation region for LED related applications, but please
reconfirm special electrical requirements for some specific system design.
5. Derating may be needed under low input voltages. Please check the static characteristics for more details.
6. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minutes.
7. Length of set up time is measured at cold first start. Turning ON/OFF the power supply may lead to increase of the set up time.
8. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
9. Direct connecting to LEDs is suggested, but is not suitable for using additional drivers.
¢J
0.45Kg;32pcs/15.4Kg/0.93CUFT
Protectiontype: Shutdownandlatchoffo/pvoltage,re-powerontorecover
60WSingleOutputSwitchingPowerSupply
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
¡E
Universal AC input / Full range
Built-in active PFC function
High efficiency up to 90%
Protections: Short circuit / Over current / Over voltage / Over temperature
Cooling by free air convection
Class 2 power unit
dimming function (1~10Vdc or PWM signal or resistance)
Suitable for LED lighting and moving sign applications
Compliance to worldwide safety regulations for lighting
3 years warranty
(up to 305VAC)
¢º
Suitable for dry / damp / wet locations
Fully isolated plastic case
Fully encapsulated with IP67 level (Note.6)
Class power unit, no FG
Built-in 3 in 1
¡½
Features :
LPF-60D series
RIPPLE&NOISE(max.) Note.2
VOLTAGETOLERANCE Note.3
ENVIRONMENT
SAFETY &
EMC
PROTECTION
90 10 (RTH2)
¢J¡Ó ¢J
Protectiontype:Shutdowno/pvoltage, re-powerontorecover
SHORTCIRCUIT
Hiccupmode,recoversautomaticallyafterfaultconditionisremoved.
54V
32.4~54V
1.12A
60.48W
350mVp-p
¡Ó
4.0%
¡Ó
0.5%
¡Ó
0.5%
42V
25.2~42V
1.43A
60.06W
250mVp-p
¡Ó
4.0%
¡Ó
0.5%
¡Ó
0.5%
90% 90%
15~17V 17.5~21V 23~27V 28~35V 34~40V 41~49V 54~63V
0.8A /115VAC0.4A /230VAC0.32A /277VAC
46~54V 59~66V
FileName:LPF-60D-SPEC 2012-09-11
LPF-60D-12 LPF-60D-15 LPF-60D-20 LPF-60D-24 LPF-60D-30 LPF-60D-36 LPF-60D-42 LPF-60D-48 LPF-60D-54
WITHSTANDVOLTAGE
ISOLATIONRESISTANCE
I/P-O/P:3.75KVAC
I/P-O/P:100MOhms/500VDC/25 /70%RH
¢J
CONSTANTCURRENTREGION Note.4
IP67
F M M
110 SELV
EMCIMMUNITY
Complianceto EN55015,EN61000-3-2ClassC( 60%load);EN61000-3-3
¡Ù
CompliancetoEN61000-4-2,3,4,5,6,8,11;EN61547,EN55024,lightindustrylevel(surge2KV),criteria A
EMCEMISSION
( for 48V,54V only) ( except for 48V,54V )
UL8750,CSA C22.2No.250.0-08(exceptfor48V,54V),EN61347-1,EN61347-2-13independent,IP67,J61347-1,J61347-2-13
approved;designrefertoUL60950-1, TUVEN60950-1