eco|matem Standard | Technical Data General Characteristics Standard Characteristics Number of contacts 3 + PE Termination technique Wire gauge / AWG Flammability 6 + PE screw type solder type crimp type 0.75 - 2.5 mm2 AWG 18-14 max. 0.75mm2 AWG 18 0.14 - 1.5 mm2 AWG 26 - 16 UL 94 VO Locking system round thread View on termination side of male contact insert Electrical Characteristics IEC 60664-1 1) Rated voltage 400 V 250 V Pollution degree IEC 60664-1 1) 3 Installation category IEC 60664-1 1) III Insulation group IEC 60664-1 1) II 1) Rated impulse withstand voltage IEC 60664-1 Current rating IEC 60512-5-2 6000 V 4000 V Contact resistance IEC 60512-2-1 5m Insulation resistance IEC 60512-3-1 108 16 A / + 55C 12 A / + 55C 13 A / + 55C Climatic Characteristics Climatic category IEC 60068-1 Operating temperature 40 / 100 /56 40 / 125 / 56 -40C ... +100C -40C ... +125C Mechanical Characteristics IP-degree IEC 60529 Insertion and withdrawal forces IEC 60512-13-2 IP 65 / IP 67 Mechanical operation IEC 60512-9-1 15 N 30 N 500 mating cycles Materials Housing material PA 6.6 / PA 6 Dielectric material PA 6.6 / PA 6 Gasket material Neopren Material lace for protective cover TPE Contact plating silver plating / gold plating Derating-Curves 2) 3 + PE 6 + PE Curve Wire gauge a 1.5 mm2 b 2.5 mm2 b 25 a 20 15 10 5 0 0 20 40 60 80 100 Umgebungstemperatur Ambient temperature (C) 120 140 30 Current Strombelastbarkeit carrying capacity Current Strombelastbarkeit carrying capacity 30 Curve Wire gauge a 0.75 mm2 stamped soldercontacts b 1.5 mm2 stamped crimpcontacts 25 20 b 15 a 10 5 0 0 20 40 60 80 100 Umgebungstemperatur Ambient temperature (C) 120 140 Remark The stated technical values refer to the use as connector without breaking capacity (COC). If these components are used as plug and socket device a reduced current carrying capacity has to be considered. The characteristics have to be requested from the manufacturer. 1) 2) DIN EN 60664-1 ^ = VDE 0110-1 ^= IEC 60664-1 All contacts under load 11