Panel Mount DataSheet 3RHP Series AC Control PRODUCT SELECTION (by control voltage and output rating) 20-26 VAC 100-130 VAC 208-240 VAC OUTPUT SPECIFICATIONS (voltage) 40A 280 VAC 50A 280 VAC 3RHP2840E 3RHP2840F 3RHP2840G 3RHP2850E 3RHP2850F 3RHP2850G 280 VAC Description 50A 600 VAC 3RHP6040E 3RHP6040F 3RHP6040G 3RHP6050E 3RHP6050F 3RHP6050G 600 VAC 24-280 0.05 mA @ 240 VAC 48-600 0.06 mA @ 480 VAC ol Operating Voltage (47-63Hz) [Vrms] Maximum Off-State Leakage Current per channel 40A 600 VAC et Control Voltage e * 100K-cycle UL508 Endurance Rating for Enhanced Reliability * 40 and 50A output * Voltage ratings to 600 VAC * Lifetime 2 million operations at full load * LED input status indicator * Wire, lug or quick connect termination * Industry Standard DP contactor mounting OUTPUT SPECIFICATIONS (current) Description Maximum Load Current per phase @ 40C [Arms] (1) Power terminals Wire Size 50 A 50A Resistive 1/4" Quick Connect and box lugs 8-14 AWG 6-14 AWG bs INPUT SPECIFICATIONS 25 A 40A Resistive 1/4" Quick Connect and 10x32 binder head screws Description Coil Voltage [50/60 Hz] Min. Turn-On Voltage Min. Turn-Off Voltage Coil Power Consumption, inrush. Coil Power Consumption, sealed. SUFIX E 20-26 VAC 20 VAC 12 VAC 56 VA @ 24 VAC 6.6 VA @ 24 VAC SUFIX F 100-130 VAC 100 VAC 24 VAC 56 VA @ 120 VAC 6.6 VA @ 120 VAC GENERAL SPECIFICATIONS Description O Dielectric Strength, Input to Output Dielectric Strength, Input/Output to ground Contacts (2) Ambient Operating Temperature Range (3) Ambient Storage Temperature Range Max. Turn-On Time 50/60 Hz Max. Turn-On Time 50/60 Hz Maximum Number of Operations Lifetime Number of Operations @ Rated Current (4) Weight (typical) Screw Torque (input/Output) 40A Screw Torque (input/Output) 50A 4000 Vrms 2500 Vrms Three Normally Open -20 to 65 C -40 to 100 C 20 ms / 16.6 ms 40 ms / 32 ms 30 per Minute >2 Million 1.19 lbs (540 g) 4.4-5 in lb (0.5-0.6 Nm) / 15-18 in lb (1.7-2.1 Nm) 4.4-5 in lb (0.5-0.6 Nm) / 20-25 in lb (2.2-2.9 Nm) GENERAL NOTES (1) See Derating curves for additional operating conditions. (2) The RHP includes a Solid State Relay, therefore electrical isolation is not provided. (3) The RHP includes over temperature protection for the solid state relay (4) 40C ambient temperature, 30 operations/min, maximum voltage control. Do not forget to visit us at: www.crydom.com Parameters Copyright (c) 2017 Crydom Inc. Specifications subject to change without notice. SUFIX G 208-240 VAC 208 VAC 48 VAC 56 VA @ 220 VAC 6.6 VA @ 220 VAC Panel Mount DataSheet MECHANICAL SPECIFICATIONS ol et e Tolerances: 0.02 in / 0.5 mm All dimensions are in: inches [millimeters] AC Line/Load Terminals #10-32 screw or .25in x .032in Dual Fast-On (Box lugs available on 50 Amps version only) Input/Control Terminals #8-32 screw or .25in x .032in Fast-On bs MECHANICAL SPECIFICATIONS 3RHPXX50XX 3RHPXX40XX 55 45 50 35 AWG # 6 AWG # 8 30 Safe Operating Area 25 45 Load Current (Amps) Power lead size O Load Current (Amps) 40 35 45 AWG # 6 AWG # 8 35 30 Safe Operating Area 25 20 20 25 Power lead size 40 55 65 75 Ambient Temperature (C) Do not forget to visit us at: www.crydom.com Copyright (c) 2017 Crydom Inc. Specifications subject to change without notice. 25 35 45 55 Ambient Temperature (C) 65 75 Panel Mount DataSheet bs ol et e TYPICAL ELECTRICAL CONNECTIONS AGENCY APPROVALS AGENCY APPROVALS UL/cUL UL5 E08, 116950 O EN60950-1-2006 Rev. 063011 Do not forget to visit us at: www.crydom.com Copyright (c) 2017 Crydom Inc. Specifications subject to change without notice. Panel Mount DataSheet O bs ol et e ACCESSORIES Do not forget to visit us at: www.crydom.com Copyright (c) 2017 Crydom Inc. Specifications subject to change without notice. Panel Mount DataSheet DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / * Verificar todas las conexiones y colocar todas las tapas antes de energizer el equipo. El incumplimiento de estas instrucciones puede provocar la muerte o lesiones serias. * Eteindre toutes les sources d'energie de cet appareil avant de travailler dessus de cet appareil GEFAHR EINES ELEKTRISCHE N SCHLAGES ODER EINER EXPLOSION. * Stellen Sie jeglichen Strom ab, der dieses Gerat versorgt, bevor Sie an dem Gerat Arbeiten durchfuhren RISCHIO DI SCOSSA ELETTRICA O DELL'ESPLOSIONE. * Spenga tutta l'alimentazione che fornisce questa apparecchiatura prima di lavorare a questa apparecchiatura * * Vor dem Drehen auf Energie alle Anschlusse uberprufen und alle Abdeckungen ersetzen. * Verifier tous connections, et remettre tous couverts en olace avant de mettre sous * Verificare tutti i collegamenti e sostituire tutte le coperture prima dell'accensione De non-suivi de ces instructions provoquera la mort ou des lesions serieuses serieuses. Unterlassung dieser Anweisungen konnen zum Tode oder zu schweren Verletzungen fuhren. L'omissione di queste istruzioni provochera la morte o lesioni serie ol Failure to follow these instructions will result in death or serious injury. * Desconectar todos los suministros de energia a este equipo antes de trabajar con este equipo. RISQUE DE DESCHARGE ELECTRIQUE OU EXPLOSION e * Verify all connections and replace all covers before turning on power. RIESGO DE DESCARGA ELECTRICA O EXPLOSION. et HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH. * Disconnect all power before installing or working with this equipment. bs WARNING / AVERTISSEMENT / WARNUNG /ADVERTENCIA / AVVERTENZA / RISK OF MATERIAL DAMAGE AND HOT ENCLOSURE RISQUE DE DOMMAGE MATERIEL ET DE SURCHAUFFE DU BOITIER GEFAHR VON MATERIALSCHADEN UND GEHAUSEERHITZUNG * The product's side panels may be hot, allow the product to cool before touching. * Follow proper mounting instructions including torque values. * Do not allow liquids or foreign objects to enter this product. * Les panneaux lateraux du produit peuvent etre chauds. Laisser le produit refroidir avant de le toucher. * Respecter les consignes de montage, et notamment les couples de serrage. * Ne pas laisser penetrer de liquide ni de corps etrangers a l'interieur du produit. * Die Seitenwande konnen hei sein. Lassen Sie das Produkt abkuhlen, bevor Sie es beruhren. * Beachten Sie die Montageanweisungen, * Fuhren Sie keine Flussigkeiten oder Fremdkorper in das Produkt ein. Die Nichtbeachtung dieser Anweisung kann Korperverletzung oder Materialschaden zur Folge haben. RIESGO DE DANOS MATERIALES Y DE SOBRECALENTAMIENTO DE LA UNIDAD RISCHIO DI DANNI MATERIALI E D'INVOLUCRO CALDO * Los paneles laterales del producto pueden estar calientes. Esperar que el producto se enfrie antes de tocarlo. * Respetar las instrucciones de montaje, y en particular los pares de apretado. * No dejar que penetren liquidos o cuerpos extranos en el producto. * I pannelli laterali dell'apparecchio possono scottare; lasciar quindi raffreddare il prodotto prima di toccarlo. * Seguire le istruzioni di montaggio corrette. * Non far entrare liquidi o oggetti estranei in questo apparecchio. Si no se respetan estas precauciones pueden producirse graves lesiones, danos materiales. La mancata osservanza di questa precauzione puo causare gravi rischi per l'incolumita personale o danni alle apparecchiature. O Le non-respect de cette directive peut entrainer, Failure to follow these instructions can result in des lesions corporelles graves ou des serious injury, or equipment damage. dommages materiels. Do not forget to visit us at: www.crydom.com Copyright (c) 2017 Crydom Inc. Specifications subject to change without notice. * * * Panel Mount DataSheet ANNEX - ENVIROMENTAL INFORMATION The environmental information disclosed in this annex including the EIP Pollution logo are in compliance with People's Republic of China Electronic Industry Standard SJ/T11364 - 2006, Marking for Control of Pollution Caused by Electronic Information Products. Toxic or hazardous Substance and Elements Lead (Pb) Mercury (Hg) Cadmium (Cd) Hexavalent Chromium (Cr (VI)) Semiconductor die Polybrominated diphenyl ethers (PBDE) et Solder Polybrominated biphenyls (PBB) e Part Name - (Pb) (Hg) (Cd) (Cr (VI)) bs ol SJ/T11364 - 2006, O 50 Do not forget to visit us at: www.crydom.com Copyright (c) 2017 Crydom Inc. Specifications subject to change without notice. (PBB) (PBDE)