Technical Data
Advance Tapes International Limited, POBox 122,
Abbey Meadows,Leicester,LE4 5RA.
Tel:0116 251 0191. Fax:0116 265 2046. www.advancetapes.com
General description
50 micron copper foil coated with an electrically conductive acrylic adhesive
supplied on a removable silicone liner.
lConductive acrylic adhesive
lGood high and low temperature resistance
lCan be easily soldered
lEasy unwind
Specification
lTested in accordance with ASTM D-1000 latest issue,BS EN 60454 - Part 2
test methods (FormerlyVDE 0340, BS 3924.)
lTested and meets military specification MIL – T - 47012
lConstruction is tested in-house and conforms to the Flame retardant
requirement part only of UL510
Technical Details
Technical details BS value ASTM value
Typical values
Foil thickness: 0.050mm 2.0 mil
Adhesive thickness: 0.025mm 1.0 mil
Total thickness: 0.075mm 3.0 mil
Adhesion to steel: 4.5 N/cm 41 oz/inch
Tensile strength: 85 N/cm 48 lbs/inch
Temperature Resistance: -20°C to +155°C Up to +311°F
Recommended curing cycle: 1 hour at 150°C or
2 hours at 130°C
Electrical resistance through
Adhesive*: 0.003 ohms
RoHS compliant Yes
Storage Temperature +12°C to +25°C
*Tested according to MIL STD 202G MIL STD 202F method 307 across surface
area of 1 sq. inch.
AT528 50 Micron Copper Foil
Shielding Tape
Issue 2 / July 2006
AFERA
Association des Fabricants Européens de
Rubans Auto-Adhésifs.
NOTE
Except where indicated otherwise,the figures stated are aver-
age values and should not be regarded as MAXIMUMor MINI-
MUM values for specification purposes.The Company reserves
the right to improve products and any change in specification
will result in a re-issue of the relevant ‘Technical Data Sheet’.
Customers should satisfy themselves that the tape is suitable
for their requirements whether after such modifications or
otherwise. Please check that you have the latest issue of the
‘Technical Data Sheet’.All slitting and length tolerances are to
British Standards.Before use the customer is advised to con-
sult the Health & Safety Data Sheet produced by the company
for this product,which is available on request.
STORAGE
Tapes stored below the minimum recommended temperature
will require warming up to that level before use.Up to 24
hours may be required for this to take place.