l- .620 [15.75] ~ pA Stewart fnnnnnnn \ Ru45 1 ISOMETRIC VIEW l- .564 [14.33] 7 .570 [14.48] 182 [4.62] 2X 6.062+.003 [01.5740.08] go06 [0.15] | .450 [11.43] 085 [2.16] | -- CT WY a ON ul DATE REV ECN APPD. BY - AO - - 182 [4.62] 128 [ 43.25 2X 0495 Ea 006 [0.15] Pattee 024 [ 40.61 i a 3 ax 0954 [ ofS 2 2 8 6x 080 004 [0.10] a ~T . Ni @g | .040 [1.02] 085 [2.16] L_ 620 [15.75] P.C.B. RECOMMENDED HOLE LAYOUT SEEN FROM COMPONENT SIDE NOTES: 249 [6.32] 279 [7.09] NX \ \ ~| .358 [9.09] | SOLDER DIPPED GROUND LEADS (2X) 125+.010 [3.1840.25] SIGNAL & GROUND LEADS ALL CENTERLINE DIMENSIONS ARE BASIC. 1. CONNECTOR MATERIALS: HOUSING: THERMOPLASTIC UL94 V-0 CONTACTS/SHIELD: COPPER ALLOY SHIELD PLATING: NICKEL OR TIN CONTACT PLATING: SELECTIVE GOLD IN CONTACT AREA SEE CHART FOR PART NUMBER 2. DIMENSIONS AND TOLERANCES COMPLY WITH TIA-1096 STANDARD. 3. DIELECTRIC WITHSTANDING VOLTAGE ( CONTACT TO SHIELD) : 2250VDC 4, HIGH TEMPERATURE PLASTIC; WAVE SOLDER COMPATIBLE TO 260C 5. FOR PRODUCT SPECIFICATION SEE PRO26-01 A\ 000, PART NUMBER AND DATE CODE LOCATED APROX. IN THIS AREA. 7. FOR PROPER JACK FUNCTION AND PERFORMANCE, TIA-1096 COMPLIANT PLUGS MUST BE USED. 50 MICRO-INCHES [1.27um] SS603500080 CONTACT PLATING IN MATING AREA PART NUMBER THIRD ANGLE PROJECTION et 11118 Susquehanna Trail South Glen Rock, PA 17327-9199 (717) 235-7512 http: //www.stewartconnector.com CONNECTOR a bel group Ae. SIGWCHI DO NOT SCALE DRAWING DRAWING IS SUBJECT TO CHANGE WITHOUT NOTICE 106, 5G, 2.5G, VERTICAL NF SHIELDED JACK DIMENSIONS: INCHES [METRIC] THIS DRAWING AND THE SUBJECT MATTER SHOWN THEREON | DRN BY: TRM DATE 8-98-17 UNLESS OTHERWSE SPECIFIED ARE CONFIDENTIAL AND THE PROPRIETARY PROPERTY OF TOLERANCES ARE 4.005 [0.13] STEWART CONNECTOR AND SHALL NOT BE REPRODUCED, APPD BY: DATE ANGIES ARE ET COPIED, OR USED IN ANY MANNER WITHOUT PRIOR WRITTEN DHG 8-28-17 CONSENT OF STEWART CONNECTOR. ONE OR MORE U.S. PATENTS SHEET NO. { OF { MAY APPLY TO THIS PRODUCT. FOR DETAILS, PLEASE | DWG NO. REY. C1600189 A0 VISIT: HTTP: //BELFUSE.COM/STEWART/STEWART_PATENTS/ | AutoCAD