60.8mm (2.4 INCH) 5x8 DOT MATRIX DISPLAY TC24-11EWA Features HIGH EFFICIENCY RED Description 2.4 INCH MATRIX HEIGHT. The High Efficiency Red source color devices are made with DOT SIZE 5mm. Gallium Arsenide Phosphide on Gallium Phosphide Orange LOW CURRENT OPERATION. Light Emitting Diode. HIGH CONTRAST AND LIGHT OUTPUT. COMPATIBLE WITH ASCII AND EBCDIC CODES. STACKABLE HORIZONTALLY. EASY MOUNTING ON P.C. BOARDS OR SOCKETS. MULTICOLOR AVAILABLE. MECHANICALLY RUGGED. STANDARD : GRAY FACE, WHITE DOT. RoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAD2474 APPROVED: J. Lu REV NO: V.5 CHECKED: Joe Lee DATE: JUN/21/2005 DRAWN: H.Q.YUAN PAGE: 1 OF 4 ERP:1332000640 Selection Guide Part No. Dice TC24-11EWA Iv (ucd) @ 10mA Lens Type HIGH EFFICIENCY RED(GaAsP/GaP) WHITE DIFFUSED Min. Typ. 1900 8000 Description Column Cathode Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. peak Peak Wavelength High Efficiency Red D Dominant Wavelength 1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating/Storage Temperature -40C To +85C Lead Solder Temperature [2] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. SPEC NO: DSAD2474 APPROVED: J. Lu REV NO: V.5 CHECKED: Joe Lee DATE: JUN/21/2005 DRAWN: H.Q.YUAN PAGE: 2 OF 4 ERP:1332000640 High Efficiency Red SPEC NO: DSAD2474 APPROVED: J. Lu TC24-11EWA REV NO: V.5 CHECKED: Joe Lee DATE: JUN/21/2005 DRAWN: H.Q.YUAN PAGE: 3 OF 4 ERP:1332000640 PACKING & LABEL SPECIFICATIONS TC24-11EWA Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD2474 APPROVED: J. Lu REV NO: V.5 CHECKED: Joe Lee DATE: JUN/21/2005 DRAWN: H.Q.YUAN PAGE: 4 OF 4 ERP:1332000640