Document Wiki
Recent Changes Media Manager Sitemap
Trace: 1.wizfi310_evaluation_board
Log In
Search
Table of Contents
WizFi310 Evaluation Board
Feature Identification
Button Description
LED Description
Pin Description
Interface Description
products:wizfi310:wizfi310qsg:1.wizfi310_evaluation_board
WizFi310 Evaluation Board
The WizFi310 EVB is the evalution board for testing WizFi310 and
prototyping development. WizFi310 EVB is composed of a WizFi310
evalution board and WizFi310 module.
Feature Identification
Button Description
WizFi310 Reset Through this button, user can restart WizFi310 module.
Function Through the function button, user can enter specific mode without AT Command.
♦ AP Mode : When module is working, press it once.
♦ OTA Mode : When module is working, press it twice.
♦ Factory Default : When module is working, press it three times.
LED Description
UART RX/TX Indicate UART RX/TX Status
Power LED Indicate Power On/Off of WizFi310
Mode LED Indicate Data/Command Mode
♦ LOW(ON) : Data Mode
♦ HIGH(OFF) : Command Mode
Wi-Fi LED Indicate Wi-Fi Association
♦ LOW(ON) : Wi-Fi is associated
♦ HIGH(OFF) : Wi-Fi is not associated
Pin Description
Products
iMCU
Pre-programmed MCU
iEthernet
S2E Module
ioModule
App Module
Wi-Fi Module
WizFi250
WizFi310
Datasheet
Programer's Guide
Quick Start Guide
WizFi310 EVB & IF
Dimension
WizFi310 EVB SCH
WizFi310
Firmware(Using
Serial)
WizFi310
Firmware(Using OTA)
WizFi630A
Mbed WIZwiki Platform
Open Source Hardware
Design Guide
VAR Products using WIZnet
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
GPIO Pin Through this pin, user can use GPIO signal
Interface Description
Debug Message Interface Through these pins, user can see debug message.
Using these pins, WizFi310 can't use AT commands.
USB Interface This provides power supply & Serial interface
Default serial information:
♦ Baud rate : 115200
♦ Data rate : 8
♦ Stop bits : 1
♦ Parity : None
♦ Flow control : None
JTAG Interface User doesn't need to know. It is used only for factory.
products/wizfi310/wizfi310qsg/1.wizfi310_evaluation_board.txt · Last modified: 2016/09/05 13:46 by cliff