Raychem Circuit Protection Raychem 308 Constitution Drive Menlo Park, CA 94025-1164 800-227-4856 FAX 800-227-4866 PRODUCT: AGR500S DOCUMENT: SCD 24702 PCN: 767948-000 REV LETTER: A REV DATE: FEBRUARY 6, 2001 PAGE NO.: 1 OF 2 PolySwitch(R) PTC Devices Resettable Fuse Specification Status: RELEASED Electrical Rating Voltage: 16V MAX Current: 100A MAX INSULATING MATERIAL: Cured, Flame Retarded Epoxy Polymer meets UL94 V-0 Requirements LEAD MATERIAL: 20 AWG Tin/Lead Plated Copper (0.81mm [0.032] nom. diameter) PART MARKING: Raychem Logo and Voltage 16 Part Identification G5 Lot Identification (can be on back) TABLE I. DIMENSIONS: A mm: in*: MIN 9.4 (0.37) B MAX 10.4 (0.41) MIN 9.4 (0.37) C MAX 14.3 0.56) MIN 4.3 (0.17) D MAX 5.8 (0.23) MIN 7.6 (0.30) E MAX - MIN 2.0 (0.08) MAX 3.0 (0.12) F TYP 1.2 (0.05) G MIN - MAX 3.94 (0.155) *Rounded off approximation TABLE II. PERFORMANCE RATINGS: I HOLD CURRENT RATINGS TIME TO TRIP RESISTANCE AMPS 25C OLD AMPS AT 25C HOLD TRIP SECONDS AT 25C, 25 A MAX OHMS AT 25C MIN MAX 5.00 5.00 8.50 Recognition: Reference Documents: Precedence: Effectivity: CAUTION: 2.0 0.015 0.034 TRIPPED-STATE POWER DISSIPATION WATTS AT 25C, 16V TYP 2.6 CSA / TUV / UL approved. PS300 This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. Raychem Circuit Protection Raychem 308 Constitution Drive Menlo Park, CA 94025-1164 800-227-4856 FAX 800-227-4866 PolySwitch(R) PTC Devices Resettable Fuse PRODUCT: AGR500S DOCUMENT: SCD 24702 PCN: 767948-000 REV LETTER: A REV DATE: FEBRUARY 6, 2001 PAGE NO.: 2 OF 2 TABLE III. AUTOMOTIVE SPECIFIC STRESS TESTS AND TEST CONDITIONS: ELECTRICAL STRESS TESTS TEST CONDITIONS (see note 2) ESD Voltage Withstand (see note 1) Short Circuit Fault Current Durability 25kV Fault Current Durability 350 cycles, 16V/100A End-of-life Mode Verification 1750 cycles, 16V/100A Jump Start Endurance (see note 1) Load Dump Endurance (see note 1) 3 cycles, 26V, 1 minute duration 25 cycles, 16V, 200A 10 cycles, 86.5V Note 1: The PolySwitch devices are tested in series with a load resistance and the voltages specified in the test conditions are shared between the PolySwitch device and the load resistance as specified in PS400. Note 2: Please refer to Appendix A of PS400 for the detailed test procedures