PRODUCT DATASHEET Dolly series last update 14/5/2012 Ordering number C10268_TITANUM-3-S Family Type LED Color Diameter Height Style Optic Material Holder Material Fastening Status Dolly Lens Golden Dragon+ Clear 50 mm 18.4 mm Round PMMA Pin, glue Ready FWHM Efficiency cd/lm Gerber File 15 degrees (simulated) 0 % 8.200 Available FWHM Efficiency cd/lm Gerber File 30 degrees (simulated) 0 % Available Ordering number C10368_TITANUM-3-M Family Type LED Color Diameter Height Style Optic Material Holder Material Fastening Status Dolly Lens Golden Dragon+ Clear 50 mm 19.9 mm Round PMMA Pin, glue Ready NOTE: The typical divergence will be changed by different color, chip size and chip position tolerance. The typical total divergence is the full angle measured where the luminous intensity is half of the peak value. September 23rd 2012 12:20 Copyright Ledil Oy - Subject to change without prior notice - Page 1/2 Ledil Oy Salorankatu 10 24240 SALO Finland http://www.ledil.com email: ledil@ledil.com FAX: +358-2-733 8001 PRODUCT DATASHEET Dolly series last update 14/5/2012 GENERAL INFORMATION - Product series especially designed & optimized for Golden Dragon+ series of LEDs. - Special care taken to make light distribution as uniform as possible. - Lens material optical grade PMMA with high UV and temperature resistance (105 degrees of Celcius / 220 degrees of Fahrenheit). Allows use of high current and temperature conditions. Please find more information about used material from below: http://ledil.fi/sites/default/files/Documents/Technical/Material/PMMA%208N%20UL94_Yellow%20Card.pdf http://ledil.fi/sites/default/files/Documents/Technical/Material/PMMA%208N%20PLEXIGLAS-Datasheet.pdf - Fastening to PCB with appropriate adhesive. By clicking link below you can find Ledil recommended glue options. http://www.ledil.com/datasheets/DataSheet_GLUES.pdf NOTE 1: We advise customer to ensure the suitability and sufficiency of the bond in the end product. For example, mechanical stress, vibration and holes on the surface of the circuit boar weaken the strength of the glue. NOTE 2: All surfaces where glue is applied must be clean, dry and free from grease and dirt. If cleaning of PCB surfaces is needed, please follow strictly the cleaning instructions of your LED manufacturer -this is important as cleaning shall under no circumstances damage LEDs or other electronics components on the PCB. Further note that optical components shall not be cleaned with any chemicals - only micro fiber cloth may be used to remove fingerprints or other traces from handling. September 23rd 2012 12:20 Copyright Ledil Oy - Subject to change without prior notice - Page 2/2 Ledil Oy Salorankatu 10 24240 SALO Finland http://www.ledil.com email: ledil@ledil.com FAX: +358-2-733 8001 Relative intensity of CA10368_Titanum-3-M 100% 75% 50% 25% 0% 70 60 50 40 30 20 10 0 -10 -20 -30 -40 -50 -60 -70