8 Pin Single-in Line Passive Delay Lines ELECTRONICS INC. EP123XXX & EP123XXX-RC Add "-RC" after part number for RoHS Compliant PCA Part Number Zo ( 10%) EP123101(-RC) EP123102(-RC) EP123103(-RC) EP123104(-RC) EP123105(-RC) EP123106(-RC) EP123107(-RC) EP123108(-RC) EP123109(-RC) EP123110(-RC) EP123111(-RC) EP123112(-RC) EP123113(-RC) EP123114(-RC) EP123115(-RC) EP123116(-RC) EP123117(-RC) EP123118(-RC) 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 Delays (nS) Rise Time (nS Max.) Zo ( 10%) EP123119(-RC) EP123120(-RC) EP123121(-RC) EP123123(-RC) EP123125(-RC) EP123127(-RC) EP123129(-RC) EP123131(-RC) EP123133(-RC) EP123135(-RC) EP123137(-RC) EP123139(-RC) EP123141(-RC) EP123146(-RC) EP123151(-RC) EP123156(-RC) EP123161(-RC) EPA594(-RC) 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 [Calculated] DC Electrical Characteristics Distortion Temperature Coefficient of Delay Insulation Resistance @ 100 Vdc Dielectric Strength 0.0 0.25 0.5 0.25 1.0 0.25 1.5 0.25 2.0 0.25 2.5 0.25 3.0 0.25 3.5 0.25 4.0 0.25 4.5 0.25 5.0 0.25 5.5 0.25 6.0 0.25 6.5 0.25 7.0 0.25 7.5 0.25 8.0 0.25 8.5 0.25 Min. ----1000 --- Pulse Width % of Total Delay Duty Cycle Operating Free-Air Temperature 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.1 1.2 1.3 1.4 1.5 1.6 1.7 1.8 Max. 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 0 9.0 0.25 9.5 0.25 10.0 0.25 11.0 0.25 12.0 0.25 13.0 0.25 14.0 0.25 15.0 0.25 16.0 0.25 17.0 0.25 18.0 0.25 19.0 0.25 20.0 0.50 25.0 0.50 30.0 0.50 35.0 0.50 40.0 0.50 45.0 1.00 Rise Time (nS Max.) DCR ( Max.) 1.9 2.0 2.0 2.2 2.3 2.5 2.6 2.8 3.0 3.2 3.4 3.6 3.8 4.5 5.5 6.4 7.4 8.0 1.0 1.0 1.0 2.0 2.0 2.0 2.0 2.0 2.5 2.5 2.5 2.5 2.5 4.0 4.5 5.5 6.0 6.5 Schematic In/Out 2 % PPM/C Meg Vdc Max. Unit 40 +70 % % C 200 Delays (nS) [Calculated] Unit 10 100 --100 Recommended Operating Conditions Min. PW* D* TA PCA Part Number DCR ( Max.) In/Out 7 1 Ground 8 Package Pin 1 I.D. (On Top) *These two values are inter-dependent. .200 Max. (5.08) .800 (20.32) .020 Input Pulse Test Conditions @ 25 C VIN PW TRI PRR Pulse Input Voltage Pulse Width % of Total Delay Input Rise Time (10-90%) Pulse Repetition Rate @ Td 150 nS Pulse Repetition Rate @ Td > 150 nS .250 Max. (6.35) Unit 3.0 300 2.0 1.0 300 Volts % nS MHz KHz Notes : 1. Lead Finish 5.0 nS .120 Typ. PCA EP123111 Min. (.508) Date Code G In Out G (3.05) .020 Typ. (.508) (Leadframe) (Assembly Solder) EP123XXX SnPb SnPb .500 (12.70) .100 Typ. (2.54) .010 Typ. (.254) .125 Typ. (3.18) EP123XXX-RC Matte Tin SnPb (RoHS exemption 7a) 2. Peak Solder Rating 4. Weight 5. Packaging Information (Tube) 245C 260C TBD grams TBD grams TBD pieces/tube TBD pieces/tube Unless Otherwise Specified Dimensions are in Inches /mm .010 /.25 PCA ELECTRONICS, INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 Product performance is limited to specified parameters. Data is subject to change without prior notice. CS123XXX & -RC Rev. - 3/6/06 RR TEL: (818) 892-0761 FAX: (818) 894-5791 http://www.pca.com