Product data sheet
Miniature connectors
Product description M16 IP67 cable connector, Contacts: 12, 4.0 - 6.0 mm, shieldable, solder, IP67, UL
Area M16 IP67 series 423
Order number 99 5129 15 12
Illustration Scale drawing Contact arrangement
You can find the component part drawing and assembly instructions on the next page.
Technical data
General values
Connector design cable connector
Connector locking system screw
Termination solder
Wire gauge (mm) 0.25 mm²
Wire gauge (AWG) 24
Cable outlet 4.0 - 6.0 mm
Upper limit temperature 95 °C
Lower limit temperature – 30 °C
Customs tariff number 85369010
Cable data
Approval 1 UL
Electrical values
Rated current (40 °C) 3 A
Rated voltage 60 V
Rated impulse voltage 500 V
Pollution degree 1
Overvoltage category I
Insulating material group III
Volume resistivity ≤ 3 mΩ
Insulation resistance ≥ 10¹⁰ Ω
EMC compliance shieldable
Degree of protection IP67
Mechanical operation > 500 Mating cycles
Material
Contact material CuZn (brass)
Contact plating Au (gold)
Contact body material PBT (UL 94 V-0)
Date: 2019-07-07 - Page 1 of 3
Product data sheet
Miniature connectors
Product description M16 IP67 cable connector, Contacts: 12, 4.0 - 6.0 mm, shieldable, solder, IP67, UL
Area M16 IP67 series 423
Order number 99 5129 15 12
Component part drawing
Assembly instructions / Panel cut-out
Date: 2019-07-07 - Page 2 of 3
Product data sheet
Miniature connectors
Product description M16 IP67 cable connector, Contacts: 12, 4.0 - 6.0 mm, shieldable, solder, IP67, UL
Area M16 IP67 series 423
Order number 99 5129 15 12
Security notices
The connectors are designed for use in plant, control system and electrical equipment. The end user is responsible
for checking whether the connectors are suitable for use in other applications.
Connectors with degree of protection IP 67 and IP 68 are not suitable for use under water. When used outdoors, the
connectors must be separately protected against corrosion. For further information about IP degrees of protection
refer to ‘Technical support’ in the Download Centre.
To lock the cable connector to the equipment connector, the threaded ring is tightened until it is ‘finger-tight’
(approx. 50 cNm).
Powered by TCPDF (www.tcpdf.org)
Date: 2019-07-07 - Page 3 of 3
