ACD-10 TRMS-PLUS - Amprobe

www.Amprobe.com

Amprobe® Test Tools

Data Sheet

No hassle

warranty

No waiting.

No shipping

charges.

Our commitment to

high-quality products

and customer service

is demonstrated by

our industry exclusive

“No Hassle” warranty.

In the unlikely event

that an Amprobe Test

Tool requires warranty

service, any of our

local dealers are

authorized to replace

it, on the spot.

(note: $500 MSLP limit)

ACD-10 TRMS-PLUS

600A Clamp-On Multimeter

TRMS Measurement ■

AC & DC Voltage to 600V ■

AC Current to 600A ■

Thin Jaws, only 10mm (0.4”) thick ■

Resistance to 40M ■W

Continuity Buzzer

■

Capacitance to 3000 uF ■

Frequency measurement ■

In rush current ■

Hold & Maximum reading functions ■

Accommodates conductors up to 26mm (1.02”) in diameter ■

Auto ranging ■

Auto power off ■

Rubber over-molded case ■

Amprobe’s ACD-10 TRMS-PLUS meter offer thinner jaws over

standard clamp meters. Allowing access to tight measurement areas

and still accommodating conductors up to 25 mm. Both meters also

measure Capacitance and Frequency. Frequency is measured by ei-

ther jaws or test leads. Very versatile clamp multimeters. True RMS

version for noisy measurement environments for a more accurate

reading.

600V

Amprobe® Test Tools www.Amprobe.com

Data Sheet

Display: 3-3/4 digits 4000 counts LCD display

Update Rate: 3 per second nominal

Polarity: Automatic

Operating Temperature: 0 °C to 40 °C; < 80% RH for temperature up to 31 °C decreasing linearly to 50% RH at 40 °C

Altitude: Operating below 2000m; Indoor use

Storage Temperature: -20 °C to 60 °C, < 80% RH (with battery removed)

Temperature Coefﬁcient: nominal 0.15 x (speciﬁed accuracy)/°C @(0 °C ~ 18 °C or 28 °C ~ 40 °C)

Low Battery: Below approx. 2.4V

Power Supply: 3V coin battery IEC-CR2032

Power Consumption: 2.8 mA typical except that 3.3 mA typical for ACA function

APO Timing: Idle for 30 minutes

APO Consumption: 5 μA typical

Dimension: 190 x 63 x 32 mm (7.4 x 2.5 x 1.3 in)

Weight: 139 gm approx

Jaw opening & Conductor diameter: max 26 mm

Special Features: 30ms Max Hold; Data Hold; Relative Zero mode

Safety: Meets EN61010-2-032, UL61010B-2-032, IEC61010-1 2nd Ed., EN61010-1

2nd Ed., UL61010-1 2nd Ed. CAT III-600 Volts ac & dc; Pollution degree : 2

EMC: Conforms to EN61326-1.

This product complies with requirements of the following European Community Directives: 89/ 336/ EEC (Electromagnetic Compatibility)

and 73/ 23/ EEC (Low Voltage) as amended by 93/ 68/ EEC (CE Marking). However, electrical noise or intense electromagnetic ﬁelds in

the vicinity of the equipment may disturb the measurement circuit. Measuring instruments will also respond to unwanted signals that

may be present within the measurement circuit. Users should exercise care and take appropriate precautions to avoid misleading results

when making measurements in the presence of electronic interference.

General Specifications

ACD-10 TRMS-PLUS 600A Clamp-On Multimeter

DC Voltage

400.0 mV ±( 0.3% + 4 digits)

4.000, 40.00, 400.0 V ±( 0.5% + 3 digits)

600 V ±( 1.0% + 4 digits)

NMRR: >50 dB @ 50/60Hz

CMRR: >120 dB @ DC, 50/60 Hz, Rs=1 kW

Input Impedance: 10 MW, 30 pF nominal (1000 MW for 400.0 mV range)

Transient protection: 6.5 kV (1.2/50 μs surge)

AC Voltage (50Hz ~ 500Hz)

4.000, 40.00, 400.0 V ±( 1.5% + 5 digits)

600 V ±( 2.0% + 5 digits)

CMRR: >60dB @ DC to 60 Hz, Rs=1 kW

Maximum Crest Factor: < 1.75 : 1 at full scale & < 3.5 : 1 at half scale limited to

fundamental and harmonics, that fall within the meter

speciﬁed AC bandwidth for non-sinusoidal waveforms

Input Impedance: 10 MW, 30 pF nominal

Transient protection: 6.5 kV (1.2/50μs surge)

ACD-10 TRMS Plus: True RMS sensing - 5 % to 100 % of range

Electrical Speciﬁcation Accuracy (23 °C ± 5 °C & < 75% R.H.)

Function Range Accuracy

www.Amprobe.com

Data Sheet

Electrical Speciﬁcation Accuracy (23 °C ± 5 °C & < 75% R.H.), cont.

ACD-10 TRMS-PLUS 600A Clamp-On Multimeter

Function Range Accuracy

AC Current (Clamp-on 50Hz / 60Hz)

Range Accuracy 1) 2) 3)

40.00, 400.0, 600 A ±( 1.5% + 8 digits)

Overload Protections: ACA Clamp-on jaws : 600 A rms continuous

ACD-10 TRMS Plus: True RMS sensing - 10 % to 100 % of range

1) Max Induced error from adjacent current carrying conductor: 0.05 A

2) Speciﬁed accuracy is from 1% to 100% of range and for measurements made at the jaw center. When the conductor is not posi-

tioned at the jaw center, position errors introduced are: Add 2% to speciﬁed accuracy for measurements made BEYOND jaw marking

lines (toward jaw opening)

3) Add 8 digits to speciﬁed accuracy @ reading < 10% of range

Resistance

400.0 W ±( 0.8% + 8 digits)

4.000, 40.00, 400.0 kW ±( 0.6% + 4 digits)

4.000 MW ±( 1.0% + 4 digits)

40.00 MW ±( 2.0% + 4 digits)

Open Circuit Voltage : 0.4 VDC typical

Transient protection : 6.5 kV (1.2/50μs surge)

Frequency

Function Sensitivity (Sine RMS) Range Accuracy

400.0 mVac 350mV 1 0 Hz ~ 2 kHz ±( 0.5%+4 digits)

4.000 Vac 1V 5 Hz ~ 5 kHz ±( 0.5%+4 digits)

4.000, 40.00 Vac 32V 5 Hz ~ 100 kHz ±( 0.5%+4 digits)

400.0 Vac 90V 5 Hz ~ 10 kHz ±( 0.5%+4 digits)

600 Vac 500V 5 Hz ~ 5 kHz ±( 0.5%+4 digits)

400.0 Aac 60A 40 Hz ~ 400 Hz ±( 0.5%+4 digits)

Display counts: 5000

Resolution: 0.001Hz

Overload Protection : ACA Clamp-on jaws : AC 600A rms continuous

Transient protection : VAC input jacks : 6.5kV (1.2/50μs surge)

Capacitance

Range 1) Accuracy 2) 3)

500.0nF, 5.000μF, ±( 3.5% + 6 digits)

50.00μF, 500.0μF, 3000μF

1) Additional 50.00nF range accuracy is not speciﬁed

2) Accuracies with ﬁlm capacitor or better

3) Speciﬁed with battery voltage above 2.8V (approximately half full battery).

Accuracy decreases gradually to 12% at low battery warning voltage of approximately 2.4V

Transient protection: 6.5 kV (1.2/50 μs surge)

Audible Continuity Tester

Audible indication: between 10 W and 120 W.

Transient protection: 6.5 kV (1.2/50 μs surge)

Diode Tester / Open Circuit Voltage Test Current

(Typical) < 1.6 VDC @ 0.25 mA

Transient protection: 6.5 kV (1.2/50 μs surge)

Max Hold* (where applicable)

Speciﬁed accuracy ± 50 digits for changes > 25 ms in duration

www.Amprobe.comwww.Amprobe.com

Amprobe® Test Tools

Data Sheet

Amprobe® Test Tools

website: www.Amprobe.com

email: info@amprobe.com

Everett, WA 98203

Tel: 877-AMPROBE

Amprobe® Test Tools Europe

In den Engematten 14

79286 Glottertal, Germany

Tel.: +49 (0) 7684 8009 - 0

9/2007 3128780 Rev A

ACD-10 TRMS-PLUS 600A Clamp-On Multimeter

Included Accessories

Test leads, battery installed, soft carrying

pouch, and users manual