3030 Series M16 [5/8 in] High Output VRS Sensors For speed sensing applications where higher output voltages are needed. Performs best at low to medium speeds with medium to high impedance loads. Optimum Actuator: 20 DP (Module 1.27) Ferrous Metal Gear Test Condition: A VP/P Specifications > Literature Parameter Value > 3010 Series General Purpose VRS Sensors Output Voltage 190V P-P min. Coil Resistance 191 Ohm to 1200 Ohms > 3015 Series General Purpose VRS Sensors Pole Piece Diameter 2,69 mm [0.106 in] Minimum Surface Speed 10 IPS (0.25 m/Sec.) Typical Operating Temperature Range -55 C to 120 C [-67 F to 250 F] Inductance 450 mH max. Gear Pitch Range 24 DP (Module 1.06) or Coarser Maximum Operating Frequency 15 KHz Typical Vibration Meets Mil-Std 202F Method 204D > 30X9 Series High Resolution VRS Sensors > 304X Series High Resolution VRS Sensors > 30X4 Series High Resolution VRS Sensors Sensors with 5/8-18 UNF-2A Mounting Thread*, MS3106 Connector > 3070/3090 Series Explosion Proof VRS Sensors > 2015/2025/2030/2040 Series Molded VRS Sensors > 3040 Series Power Output VRS Sensors Dimensions Part Number Thread Length Weight 3030AN 28 mm [1.1 in] 70 g [2.5 oz] 3030AN25 63 mm [2.5 in] 84 g [3.0 oz] 3030AN30 76 mm [3.0 in] 84 g [3.0 oz] 3030AN40 101 mm [4.0 in] 98 g [3.5 oz] 3030AN50 127 mm [5.0 in] 128 g [4.5 oz] Mates with 41010(VR) Connector or CA210 Cable Assembly. * For M16 x 1.5 6g Mounting Thread Versions, add "M" as the first character of the model number. Sensors with 5/8-18 UNF-2A Mounting Thread*, 24" (300 mm) Leads Dimensions Part Number Thread Length Weight 3030S20 50 mm [2.0 in] 70 g [2.5 oz] 3030S30 76 mm [3.0 in] 84 g [3.0 oz] * For M16 x 1.5 6g Mounting Thread Versions, add "M" as the first character of the model number. > 3080 Series Sub Miniature VRS Sensor Sensors with 5/8-18 UNF-2A Mounting Thread*, 1/2-14 NPT Conduit Mount, 300 mm [24 in] Leads > 3015HTB Series High Temperature VRS Sensors > Download VRS Calculator Dimensions Part Number Thread Length Weight 3030H20 50 mm [2.0 in] 140 g [5.0 oz] * For M16 x 1.5 6g Mounting Thread Versions, add "M" as the first character of the model number. Sensors with 5/8-18 UNF-2A Mounting Thread*, MS3106 Connector, 7,9 mm [0.312 in] Thread Relief Dimensions Part Number Thread Length Weight 3030A 1.4" (35 mm) 2.5 oz. (70 gr.) 3030A25 2.5" (63 mm) 3.0 oz. (84 gr.) Mates with 41010(VR) Connector or CA210 Cable Assembly. * For M16 x 1.5 6g Mounting Thread Versions, add "M" as the first character of the model number.