SPEC NUMBER: 205-03-252 KYOCERA ELCO CORPORATION CRIMPING OPERATIONAL MANUAL SERIES CONTACT-CRIMP TYPE O EDN-249 07/11 `11 H.Tamai NO EDN/DCN DATE PREPARED 106-03-003 H.Sadatoku CHECK APPROVED KYOCERA ELCO CORPORATION ENGINEERING DEPT. KYOCERA ELCO CORPORATION 1. Application This operation manual specifies the certain conditions for the crimping contact shown below. Part number range 71 9609 999 20X 808 + UL STYLE 10368 AWG22 insulation wire 1.4 max. mm Note *** m 808 + All Over Sn Reflow Plating 0.81.5m 2. Name of each Bend up Twist Rolling Bend down Extended length of conductor Bell mouth Insulation crimp height Wire crimp height 1 Cut off tab length Fig1 3. Specifications 1 Position in Fig1 Name of each Bend up Bend down Specification 1.5MAX. 1.5MAX. Twist Rolling Bellmouth(Ref.) Cut-off tab length Wire extruded length 2.0MAX. 5.0MAX. 0.10.15mm 0 0.3 mm 0.10.5 mm SERIES 9609 CRIMPING OPERATIONAL MANUAL 106-03-004 SPEC No.205-03-252 PAGE 1/2 KYOCERA ELCO CORPORATION Seam on wire crimp area Wire strip length Seam to be closed. No wire extrusion is not permitted, if open. 1.31.7mm 4. Crimping Specification and of Fig 1 Contact NO 71 9609 999 20X 808 + 1 Wire crimp barrel of Fig 1 Applicator AWG Wire size NO mm mm Height Width 36 1000 061 #22 1.250.05 0.750.03 1 Insulation crimp barrel of Fig 1 mm mm Height Width 1.50.05 Nkgf MIN Crimp tensile strength 1.40.05 30N 3.0kgf MIN. Note Crimped contact has to be free from any damages on the necessary performances after insertion into the insulator. SERIES 9609 CRIMPING OPERATIONAL MANUAL 106-03-004 SPEC No.205-03-252 PAGE 2/2 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: AVX: 109609001001808+ 249609001000808+ 979609001007808+ 979609001008808+