Available on Tape
and Reel For Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
(315) 432-8909
(800) 544-2414
+44 2392-232392
Model
A50A50X4
Features:
• DC – 3.5 GHz
• 50 Watts
• Alumina Ceramic
• Non-Nichrome Resistive
Element
• Low VSWR
• 100% Tested
• RoHS Compliant
Chip Termination
50 Watts, 50Ω
General Specifications
Resistive Element Thick film
Substrate Alumina
Terminals Matte Tin over Nickel
Electrical Specifications
Resistance Range: 50 ohms, ± 2%
Frequency Range; DC – 3.5 GHz
Power: 50 Watts
VSWR 1.1:1 DC – 2.7 GHz
1.25:1 DC – 3.5 GHz
Note: Tolerance is ±0.010”, unless otherwise specified. Designed to meet of
exceed applicable portions of MIL-E-5400. Operating temperature is -55ºC to
125ºC (see chart for derating temperatures).
All dimensions in inches.
Specifications subject to change with out notice.
Outline Drawing
A50A50X4 (097) Rev G
ROHS
Compliant
USA/Canada:
Toll Free:
Europe:
(315) 432-8909
(800) 544-2414
+44 2392-232392
Available on Tape and
Reel For Pick and Place
Manufacturing.
Model
A50A50X4
Typical Performance:
Power De-rating: Mounting Footprint and Procedure:
NOT RECOMMENDED APPLICATION
BOARD LOWER
THAN LEAD. THAN LEAD.
BOARD HIGHER
SCALE: NONESCALE: NONE
BOARD EVEN
WITH LEAD.THAN LEAD.
BOARD LOWER
SUGGESTED STRESS RELIEF METHODS
(2 PLACES)
.025 MIN.
SUGGESTED MOUNTING PROCEDURES:
1. MAKE SURE THAT THE DEVICES ARE MOUNTED ON
FLAT SURFACES (.001" UNDER THE DEVICE) TO
OPTIMIZE THE HEAT TRANSFER.
DRILL & TAP THE HEATSINK FOR THE APPROPRIATE2.
THREAD SIZE TO BE USED.
3. COAT HEATSINK WITH A MINIMUM AMOUNT OF HIGH
QUALITY SILICONE GREASE (.001" MAX. THICKNESS).
4. POSITION DEVICE ON MOUNTING SURFACE & SECURE
USING SOCKET HEAD SCREWS, FLAT & SPLIT WASHER.
TORQUE SCREWS TO THE APPROPRIATE VALUE. MAKE
5.
SURE THAT THE DEVICE IS FLAT AGAINST THE HEATSINK.
(CARE SHOULD BE TAKEN TO AVOID UPWARD PRESSURE OF
THE LEADS TOWARDS THE LID).
SOLDER LEADS IN PLACE USING APPROPROATE SOLDER WITH
A CONTROLLED TEMPERATURE IRON.
** FOR MORE DETAILS CONTACT FACTORY **
A50A50X4 (097) Rev G
