Corporate Office: 1097 N. Batavia St. Orange, CA 92867 Material Specification Sheet LTX 600 Thermal Transfer Gloss White Polyester Product Description A general purpose, high performance polyester label film. LTX 600 is UL approved, when printed with a LABELTRONIX(R) 200 PlusTM or 500 PlusTM ribbon under UL# MH26576. This facestock resists tearing, abrasion and heat. The gloss white surface makes label graphics easy to read. Facestock Description A gloss, topcoated, thermal transfer printable, white polyester. Test Property ......................................................................Typical Values Type......................................................................................Gloss White Polyester Caliper (mils) ........................................................................2.0 10% Ribbon Compatibility.............................................................200 PlusTM, 500 PlusTM Adhesive Description An aggressive, high performance permanent adhesive. This adhesive offers high initial tack, high shear, and high ultimate bond to a wide variety of surfaces. Test Property ......................................................................Typical Values Type......................................................................................General Purpose Acrylic Application Temperature (Minimum) ....................................50F Service Temperature Range ................................................-40F to 302F Liner Description Test Property ......................................................................Typical Values Type......................................................................................Bleached Kraft Caliper (mils) ........................................................................3.1 10% Recommendations * * * One-year shelf life from receipt of material, if properly stored. Recommended storage conditions are 72F (22C) and 50% relative humidity. Good for use in: UL rating plates and nameplates, material tracking, under the hood labels, parts identification, and asset management labels. As with all pressure-sensitive materials, LABELTRONIX recommends this product be tested thoroughly under end-use conditions to make sure it meets the requirements of the specific application. Please note that the above data represents expected averages with variances following industry standards. They should not be misinterpreted as minimum or absolute values. This specification sheet was updated and confirmed as of 4/09/03. 800.429.4321 www.labeltronix.com Fax 800.419.1555