Corporate Office: 1097 N. Batavia St. Orange, CA 92867 Material Specification Sheet
LTX 600 Thermal Transfer Gloss White Polyester
Product Description
A general purpose, high performance polyester label film. LTX 600 is UL approved, when printed with a
LABELTRONIX® 200 Plus™ or 500 Plus™ ribbon under UL# MH26576. This facestock resists tearing,
abrasion and heat. The gloss white surface makes label graphics easy to read.
Facestock Description
A gloss, topcoated, thermal transfer printable, white polyester.
Test Property ......................................................................Typical Values
Type......................................................................................Gloss White Polyester
Caliper (mils) ........................................................................2.0 ± 10%
Ribbon Compatibility.............................................................200 Plus™, 500 Plus™
Adhesive Description
An aggressive, high performance permanent adhesive. This adhesive offers high initial tack, high shear, and
high ultimate bond to a wide variety of surfaces.
Test Property ......................................................................Typical Values
Type......................................................................................General Purpose Acrylic
Application Temperature (Minimum) ....................................50˚F
Service Temperature Range ................................................-40˚F to 302˚F
Liner Description
Test Property ......................................................................Typical Values
Type......................................................................................Bleached Kraft
Caliper (mils) ........................................................................3.1 ± 10%
Recommendations
One-year shelf life from receipt of material, if properly stored.
Recommended storage conditions are 72°F (22°C) and 50% relative humidity.
Good for use in: UL rating plates and nameplates, material tracking, under the hood labels, parts
identification, and asset management labels.
As with all pressure-sensitive materials, LABELTRONIX recommends this product be tested thoroughly
under end-use conditions to make sure it meets the requirements of the specific application.
Please note that the above data represents expected averages with variances following industry
standards. They should not be misinterpreted as minimum or absolute values.
This specification sheet was updated and confirmed as of 4/09/03.
800.429.4321 www.labeltronix.com Fax 800.419.1555