MICRO SWITCH TOGGLE O7ETI-T SWITCH _ 2 a Honeywell Division (MAGNE TIC HOLD-IN) 1 TE 3 FED. MFG. CODE 91929 Le 5 4 | 4 C'S | | 6 g | 28 < VDC a COIL 8 _ i | V POSITION B CIRCUITS 1-2 AND 4-5 MADE CIRCUIT DIAGRAM a 9 (MECHANICALLY MAINTAINED) rey 388 (MECHANICALLY MAINTAINED LJ Sy oo POSITION B) ~ |e POSITION C | 30#4 TOTAL TRAVEL - a CIRCUITS 1-2 AND 4-6 MADE N |: (ELECTRICALLY MAINTAINED POSITION) POSITION A D.240 LEVER (MATTE FINISH) | uw CIRCUITS 1-3 AND 4-5 MADE .072#.004 WIDE X .031 DEEP KEYWAY z < (ELECTRICALLY MAINTAINED TO WITHIN .250 OF SOULDER old % 047 HOLE POSITION) 4 * FOR WIRE LOCKING \" '] 34 1573232UNS THREAD TO WITHIN .090 OF SHOULDER g bs 1.160 #.030 { K x - 2X HEX NUTS ,62 ACROSS FLATS X .125 THICK / \ oo AT on V CORROSION RESISTANT STEEL INTERNAL TOOTH |_| LOCKWASHER @ .60 X (.018) THICK (MS 35333-136 u 05 | o |O | KEYING WASHER @ .72 X .31 THICK, TAB .110 WIDE J z 2.280 MAX oN RE istons] _| A |co79565 JW 6 AUG 96 | NOTES | 1 EXPOSED PARTS ARE OF CORROSION RESISTANT 3 MATERIAL OR ARE SUITABLY PROTECTED TO PRE- = VENT CORROSION, ENCLOSURE FINISHED WITH BLUE EPOXY BASED ENAMEL COLOR NO. 25184 PER FEDERAL STANDARD 595 | 2 SWITCH SEALED PER MILS5594 HOLD IN VOLTAGE: THE MINIMUM SPECIFIED VOL | TAGE AT WHICH THE LEVER WILL REMAIN ACTUATED. HOLD IN MAY OCCUR AT A LOWER VALUE. DROP OUT VOLTAGE: THE VOLTAGE RANGE IN WHICH THE LEVER WILL BE RELEASED THIS DRAWING COVERS A PROPRIETARY ITEM AND IS THE PROPERTY OF MICRO SWITCH. A DIVISION OF THIRD ANGLE PROJECTION 4 ~~ CIRCUITS CAN BE TRANSFERRED MANUALLY. | HONEYWELL. THIS DRAWING IS NOT TO BE COPIED OR USED WITHOUT THE APPROVAL OF MICRO SWITCH +6) + ENERGIZING THE COIL WILL NOT CAUSE TRANS S FER OF CIRCUITS 3 CHARACTERISTICS 3 \ ELECTRICAL DATA SCALE FULL CIRCUIT IDENTIFICATION IS SHOWN ON SWITCH co SOLENOID RATING AT 20 Cc CONTA Dey MENT DO NOT SCALE PRINT /6\ WEIGHT OF SWITCH ONLY 4.0 OZ MAX HARDWARE MAY BE FURNISHED UNASSEMBLED . STEAD STATE LIMITS ~ a voc RATINGS IN AMPHERES eee OLERANCES ARE LN PER MIL-S5594 SS PHOLD IN ~~ ~~ ONE PLACE (.0) +.030 a <P prop out 0-15 VDC VOLTAGE SEA LEVEL 65,000 FT TWO PLACE (.00) +.015 O = 0 | COIL RESISTANCE 220 OHM MIN INRUSH]|RES| IND |MOTOR |INRUSH|RES| IND | MOTOR THREE PLACE (.000) +.005 > a = J opeRATING FORCE 7 LBS MAX a6 VOLTS DS 72 sis ANGLES + a > OVERRIDE FORCE CO |eofaras vo 10 LBS MAX weisnt /6\ ANSI_Y14.5M1982_ APPLIES