zQSFP+ Multi-Port Connector Tooling 2-by-3 zQSFP+ Insertion Tool Application Tooling Specification Sheet Order No. 62202-5270 FEATURES Lightweight tool used in the insertion of a zQSFP+ connector in a PCB Inserts connector to a PCB without damage to the board Use tool 62202-5230 for removing connectors PCB support not included (furnished by customer). SCOPE Products: zQuad Small Form-factor Pluggable Plus (zQSFP+) Cage Assembly, with Elastomeric Gasket or Metal EMI Gasket, 2 by 3 Enhanced EMI Cage Construction. Connector Series No. Connector Order No. 171233 171233-1010 Notes: 1. See the following pages for tooling operation instructions. 2. These tools require a "Keep Out Zone" around the connector free of components. The right and left sides should be 2mm (0.08") and the rear of the connector should be 5.0mm (.197"). See Figure 1. zQSFP+ CAGE ASSEMBLY 5.0mm MINIMUM Figure 1 PCB 2.0mm MINIMUM (BOTH SIDES) KEEP OUT ZONE Doc. No: ATS-622025270 Revision: A Release Date: 10-04-13 Revision Date: 10-04-13 UNCONTROLLED COPY Page 1 of 2 zQSFP+ Multi-Port Connector Tooling Description INSERTION TOOL OVER CONNECTOR ASSEMBLY The following Instructions are used for inserting the 2 by 3 connector into a PCB. Operation 1. Place a connector assembly on the PCB. 2. Place the tool on the connector assembly (closed end to the back end of the connector). See Figure 2. 3. Place tool, connector, and PCB, in a press of suitable size and force, and seat the connector assembly as shown. The support plate (furnished by the customer) under the PCB must have clearance for the connector pins as they pass through the PCB. INSERTION TOOL (CLOSED END) BOTTOM OF CONNECTOR TO SEAT FLUSH ON PCB zQSFP+ CONNECTOR ASSEMBLY PCB Figure 2 SIDE PLATE Clearance 1.0mm CLEARANCE BETWEEN BOARD AND THE SIDE PLATE AFTER zQSFP+ ASSEMBLY IS SEATED ONTO THE PCB PCB Figure 3 Use this tool only with a press that has a pre-determined shut height when seating a zQSFP+ Assembly on a PCB. See figure 3. Allowing the Press-In Tool to stop on the board will result in damage the zQSFP+ cage and terminals being over seated. CAUTION: Molex application tooling specifications are valid only when used with Molex connectors and tooling. Contact Information For more information on Molex application tooling please contact Molex at 1-800-786-6539. Visit our Web site at http://www.molex.com Doc. No: ATS-622025270 Revision: A Release Date: 10-04-13 Revision Date: 10-04-13 UNCONTROLLED COPY Page 2 of 2