-1-
GENERAL NOTES
Use these notes when setting up to test any testable CRT. These notes are
applicable to all B&K Precision CRT Tester/Rejuvenators, and for all tube types
in this Setup Chart.
1. The 490B use CA adapters. There are some tubes that do not have CA
adapters available. In these cases a CR adapter can be used on a 490B with
the use of a CC-12 cable adapter. 490B users will need the CC-12 adapter
cable when using the CR-XA Universal Adapter.
2. Set G1 to 50 V, Except for…
CRTs marked with (@), set G1 to 100 V
CRTs marked with (*), set G1 to 70 V
CRTs marked with (**), set G1 to 30 V
CRTs marked with (@@), 467 & 490 set G1 to 30V, 470 & 480 set G1 to 20V
3. CRTs marked with (#), Red and Green guns interchanged (test Red gun with
Green controls, and vice versa.)
CRTs marked with (##), Red and Blue Guns interchanged (test Red gun with
Blue controls, and vice versa.)
4. Prefix and suffix letters were deleted from CRT types, unless otherwise
specified (e.g., MV13VAHP22 is tested as 13VAHP22 and 25BP22A is tested
as 25BP22, A36JAR50X09 is tested as A36JAR50X, etc.)
5. CRTs with integral convergence assemblies, whose designation terminates
with TC01 or TC02, instead of P22, are tested in the same manner (e.g.,
19VDKTC01 are tested as 19VDKP22.)
6. Unless otherwise noted, test monochrome CRTs (includes green, amber,
black & white CRTs, etc., as well as most projection CRTs) on the RED/B&W
position.
7. For testing CRTs that are not listed in this SETUP Chart, you can contact the
manufacturer of the CRT to get the pin-outs of the CRT gun, or ask for a
match to a more common tube type with the same pin outs. Listed below are
the major CRT manufacturers.
Panasonic: (201) 392-4207 For computer monitors call (800) 726-2797
Hitachi: (800) 448-2244
Sony: (800) 236-1877
New Setup Charts with new tube listings will be published annually.