F-213 SUPPLEMENT (Rev 25NOV13) (0,635 mm) .025" 6QDP SERIES 6QDP-016-06.0-STR-TBR-3-B 6QDP-032-06.0-STR-TTR-2 HIGH SPEED TWINAX CABLE ASSEMBLIES SPECIFICATIONS Mates with: QMS-DP, QFS-DP For complete specifications see www.samtec.com?6QDP Increased Insertion Depth Cable: 30 AWG twinax micro ribbon Signal Routing: 100 Differential Cable Bending Radius: (11,11 mm) 7/16" min Plating: Au over 50" (1,27 m) Ni Current Rating: 700 mA per pin (6 adjacent pins powered) Propagation Delay: 4.67 nsec/meter Operating Temp Range: -40C to +105C Skew (pair-to-pair): <10 ps/ft Skew (within a pair): <5 ps/ft EMI Performance: FCC Class A RoHS Compliant: Yes APPLICATIONS 30 AWG twinax ribbon cable Differential Pair routing END NO. 1 WIRE LENGTH NO. OF PAIRS TYPE -"XX.X" 6QDP APPLICATIONS = Unshielded mates with QMS-DP/QFS-DP (15,11) .595 -016, -032, -048, -064 = Wire Length in Inches (43,7 mm) 01.7" minimum ALSO AVAILABLE OAL = Wire Length + L (MOV Required) Wire Length (1,27) .050 SCREW OPTION -1 Leave blank for no Screw Option = Pin 1 to Pin 1 -2 = Pin 1 to Second Last Pin (23,88) .940 -4 Note: Cable lengths longer than 40.00" (1 meter) are not supported with S.I. test data. (7,47) .294 END NO. 2 (-STR SHOWN) END 1 WWW.SAMTEC.COM = End No. 2 -B = Both Ends = Pin 1 to Last Pin SURFACE MOUNT -TTR =Terminal, Top, Notch Right -TTL = Terminal, Top, Notch Left -TBR = Terminal, Bottom, Notch Right -TBL = Terminal, Bottom, Notch Left -STR = Socket, Top, 001 Notch Right -STL = Socket, Top, 064 Notch Left -SBR = Socket, Bottom, Notch Right 001 -SBL = Socket, Bottom, Notch Left 064 -F = End No. 1 -S -3 L ASSEMBLY END NO. 1 (-TTL SHOWN) WIRING OPTION = Pin 1 to Pin 2 * Other pin counts * Other terminations Contact Samtec. Note: Design your High Speed Cable with Samtec's High Speed Cable Solutionator(R) at www.samtec.com/hdr Note: This Series is non-standard, non-returnable. Specify END ASSEMBLIES from chart END TO END Surface Mount to Surface Mount Processing conditions will affect mated height. END NO. 2 END 2 064 064 001 001 064 064 001 001 WIRING REQUIREMENTS WIRING END OPTIONS OPTION 001 064 001 064 1 or 2 3 or 4 TTR, TBL, STL, SBR to TTR, TBL, STL, SBR or TTL, TBR, STR, SBL to TTL, TBR, STR, SBL TTL, TBR, STR, SBL to TTR, TBL, STL, SBR or TTR, TBL, STL, SBR to TTL, TBR, STR, SBL