https://www.phoenixcontact.com/us/products/2891391 Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) Wide-temperature Ethernet switch, five TP RJ45 ports, automatic detection of data transmission speed of 10/100/1000 Mbps (RJ45), autocrossing function, reads QoS priority messages, accepts security frames. Conformal coating for harsh environments. Product Description The FL SWITCH SFN 5GT supports the auto negotiation function at the twisted-pair ports and offers transmission speeds of 10/100/1000Mbps. Mixed operation for the connection of segments with different data transmission speeds is also supported. Switching properties -Multi-address function The switch can store up to 8192 MAC addresses in its address table. -Quality of service In case of heavy traffic, packets tagged with higher priority 802.1Q or Differentiated Services values will be given preference. The switch has four internal priority queues. -Multicast filtering The multicast filter will block PROFINET PTCP-Delay traffic. This is accomplished by filtering frames with the destination MAC address in the range 01-80-C2-00-00-02 through 01-80-C2-00-00-0F. Note that the filter blocks LLDP traffic because PTCP-Delay uses the same MAC address, 01-80C2-00-00-0E. -Alarm contact The switch provides contacts (R1, R2) for remote alarms if a failure is detected. Alarms are triggered if one or both power supplies fail. An alarm can be triggered if a port link is lost. Individual port alarms can be enabled via a DIP switch located on the bottom of the switch. The alarm relay is a normally closed type. When there are no faults, the contact is held open. When a fault occurs, the relay is de-energized to close the contact. -Link monitor DIP switch To enable an alarm for a port, move the appropriate slider to the ON position. To disable an alarm, move the appropriate slider to the OFF position. Power connection is via a removable COMBICON connector. US1 and US2 are 24 V DC and GND is 0 V DC. FE symbol is functional earth. Your advantages All ports offer transmission speeds of 1000 Mbps Jumbo frame support (frame size up to 10,240 bytes/frame) QoS-prioritized (Quality of Service) messages The switch also offers cable locking and port blocking Alarm contact for power supply and link status diagnostics Wide operating temperature range (-40C ... +75C) 12/05/2020Page1/8 https://www.phoenixcontact.com/us/products/2891391 Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391 Key Commercial Data Packing unit 1 pc GTIN GTIN 4055626001104 Weight per Piece (excluding packing) 550.000 g Custom tariff number 85176200 Country of origin Taiwan Technical data Note Utilization restriction EMC: class A product, see manufacturer's declaration in the download area Use in potentially explosive areas is not permitted in China. Dimensions Width 30 mm Height 130 mm Depth 100 mm Ambient conditions Degree of protection IP20 Ambient temperature (operation) -40 C ... 75 C Ambient temperature (storage/transport) -40 C ... 85 C Permissible humidity (operation) 5 % ... 95 % (non-condensing) Air pressure (operation) 62 kPa ... 108 kPa (up to 4850 m above mean sea level) Air pressure (storage/transport) 62 kPa ... 108 kPa (up to 4850 m above mean sea level) Interfaces Interface Ethernet (RJ45) No. of ports 5 (RJ45 ports) Note on the connection method Auto negotiation and autocrossing Transmission physics Ethernet in RJ45 twisted pair Transmission speed 10/100/1000 Mbps Function 12/05/2020Page2/8 https://www.phoenixcontact.com/us/products/2891391 Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391 Technical data Function Basic functions Unmanaged switch / autonegotiation, complies with IEEE 802.3, store and forward switching mode, includes QoS and alarm contact Additional functions Autonegotiation Jumbo frames (Max. 10,240 bytes) PROFINET conformance class Conformance-Class A Status and diagnostic indicators LEDs: US1, US2 (redundant voltage supply), link and activity per port Network expansion parameters Cascading depth Network, linear, and star structure: any Maximum conductor length (twisted pair) 100 m Supply voltage Supply voltage 24 VDC (redundant) Residual ripple 3.6 VPP (within the permitted voltage range) Supply voltage range 10 VDC ... 60 VDC Typical current consumption 223 mA (at US = 24 V DC) Max. current consumption 547 mA (10 V DC) Inrush current 7.2 A (400s) General Mounting type DIN rail Type AX Block design Net weight 510.6 g Housing material Aluminum MTTF 121.4 Years (MIL-HDBK-217F standard, temperature 25C, operating cycle 100%) Standards and Regulations Electromagnetic compatibility Conformance with EMC Directive 2004/108/EC Noise emission EN 61000-6-4 Noise immunity EN 61000-6-2:2005 Environmental Product Compliance REACh SVHC Lead 7439-92-1 China RoHS Environmentally Friendly Use Period = 10; For details about hazardous substances go to tab "Downloads", Category "Manufacturer's declaration" Drawings 12/05/2020Page3/8 https://www.phoenixcontact.com/us/products/2891391 Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391 Connection diagram + - + Connection diagram - + - US1 GND US2 GND Redundant power supply connection R1 R2 US1 GND US2 GND R1 R2 Single power supply connection Classifications eCl@ss eCl@ss 10.0.1 19170402 eCl@ss 11.0 19170402 eCl@ss 5.0 19030100 eCl@ss 5.1 19030100 eCl@ss 6.0 19170100 eCl@ss 7.0 19170106 eCl@ss 8.0 19170106 eCl@ss 9.0 19170106 ETIM ETIM 5.0 EC000734 ETIM 6.0 EC000734 ETIM 7.0 EC000734 UNSPSC UNSPSC 13.2 43222612 UNSPSC 18.0 43222612 UNSPSC 19.0 43222612 UNSPSC 20.0 43222612 UNSPSC 21.0 43222612 Approvals Approvals 12/05/2020Page4/8 https://www.phoenixcontact.com/us/products/2891391 Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391 Approvals Approvals UL Listed / cUL Listed / EAC / cULus Listed Ex Approvals UL Listed / cUL Listed / cULus Listed Approval details UL Listed http://database.ul.com/cgi-bin/XYV/template/LISEXT/1FRAME/index.htm FILE E 140324 cUL Listed http://database.ul.com/cgi-bin/XYV/template/LISEXT/1FRAME/index.htm FILE E 140324 EAC RU*-DE.*.B.00741/19 cULus Listed Accessories Accessories Assembly adapter Mounting plate-FL PA SFNT 5-8-2891012 Mounting plate for SFNT switches Data cable preassembled 12/05/2020Page5/8 https://www.phoenixcontact.com/us/products/2891391 Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391 Accessories Patch cable-NBC-R4AC-R4AC-IE8A/.../...-1411854 Patch cable, degree of protection: IP20, number of positions: 8, 10 Gbps, CAT6A, cable outlet: straight Patch cable-NBC-R4AC/10G-R4AC/10G-94F/2,0-1408360 Patch cable, CAT6A, 4-pair, shielded, connection not crossed (line), assembled at both ends with RJ45/IP20 connectors, outer sheath material: PUR, length: 2.0 m Patch cable-NBC-R4AC/10G-R4AC/10G-94F/3,0-1408365 Patch cable, CAT6A, 4-pair, shielded, connection not crossed (line), assembled at both ends with RJ45/IP20 connectors, outer sheath material: PUR, length: 3.0 m End block End clamp-E/NS 35 N-0800886 End clamp, width: 9.5 mm, color: gray Mounting rail adapter DIN rail adapter-FL DIN RA-2891053 The FL DIN RA is installed in a standard, 19-inch rack (EIA-310-D, IEC 60297-3-100) to allow DIN rail mounted equipment to be rack mounted. 12/05/2020Page6/8 https://www.phoenixcontact.com/us/products/2891391 Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391 Accessories Patch cable Patch cable-FL CAT5 PATCH 0,5-2832263 Patch cable, CAT5, assembled, 0.5 m Patch cable-FL CAT5 PATCH 1,0-2832276 Patch cable, CAT5, assembled, 1 m Patch cable-FL CAT5 PATCH 2,0-2832289 Patch cable, CAT5, assembled, 2 m PCB plug Printed-circuit board connector-MSTB 2,5/ 3-ST-1754465 PCB connector, nominal cross section: 2.5 mm, color: green, nominal current: 12 A, rated voltage (III/2): 320 V, contact surface: Tin, type of contact: Female connector, Number of potentials: 3, Number of rows: 1, Number of positions per row: 3, number of connections: 3, product range: MSTB 2,5/..-ST, pitch: 5 mm, connection method: Screw connection with tension sleeve, conductor/PCB connection direction: 0 , Stecksystem: CLASSIC COMBICON, Locking: without, type of packaging: packed in cardboard Protective cap 12/05/2020Page7/8 https://www.phoenixcontact.com/us/products/2891391 Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391 Accessories Dust protection-FL RJ45 PROTECT CAP-2832991 Dust protection caps for RJ45 socket Safety locking Port Guard Security Element-FL SEC PAC 4TX-2832865 Layer1 security elements for four RJ45 network connections for use with patch boxes and panels Surge protection for information technology Surge protection device-DT-LAN-CAT.6+-2881007 Surge protection in accordance with Class EA (CAT6A), for Gigabit Ethernet (up to 10 Gbps), token ring, FDDI/CDDI, ISDN, and DS1. Suitable for Power over Ethernet (PoE+) "Mode A" and "Mode B". RJ45 attachment plug with separate grounding cable and ground connection snap-on foot for NS 35 DIN rails. Phoenix Contact 2020 (c) - all rights reserved http://www.phoenixcontact.com 12/05/2020Page8/8