https://www.phoenixcontact.com/us/products/2891391
12/05/2020Page1/8
Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391
Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's
documentation. Our General Terms of Use for Downloads are valid
(http://phoenixcontact.com/download)
Wide-temperature Ethernet switch, five TP RJ45 ports, automatic detection of data transmission speed of
10/100/1000 Mbps (RJ45), autocrossing function, reads QoS priority messages, accepts security frames.
Conformal coating for harsh environments.
Product Description
The FL SWITCH SFN 5GT supports the auto negotiation function at the twisted-pair ports and offers transmission speeds of 10/100/1000Mbps. Mixed
operation for the connection of segments with different data transmission speeds is also supported.
Switching properties
-Multi-address function
The switch can store up to 8192 MAC addresses in its address table.
-Quality of service
In case of heavy traffic, packets tagged with higher priority 802.1Q or Differentiated Services values will be given preference. The switch has four
internal priority queues.
-Multicast filtering
The multicast filter will block PROFINET PTCP-Delay traffic. This is accomplished by filtering frames with the destination MAC address in the range
01-80-C2-00-00-02 through 01-80-C2-00-00-0F. Note that the filter blocks LLDP traffic because PTCP-Delay uses the same MAC address, 01-80-
C2-00-00-0E.
-Alarm contact
The switch provides contacts (R1, R2) for remote alarms if a failure is detected. Alarms are triggered if one or both power supplies fail. An alarm can be
triggered if a port link is lost. Individual port alarms can be enabled via a DIP switch located on the bottom of the switch. The alarm relay is a normally
closed type. When there are no faults, the contact is held open. When a fault occurs, the relay is de-energized to close the contact.
-Link monitor DIP switch
To enable an alarm for a port, move the appropriate slider to the ON position. To disable an alarm, move the appropriate slider to the OFF position.
Power connection is via a removable COMBICON connector. US1 and US2 are 24 V DC and GND is 0 V DC. FE symbol is functional earth.
Your advantages
All ports offer transmission speeds of 1000 Mbps
Jumbo frame support (frame size up to 10,240 bytes/frame)
QoS-prioritized (Quality of Service) messages
The switch also offers cable locking and port blocking
Alarm contact for power supply and link status diagnostics
Wide operating temperature range (-40°C ... +75°C)
https://www.phoenixcontact.com/us/products/2891391
12/05/2020Page2/8
Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391
Key Commercial Data
Packing unit 1 pc
GTIN
GTIN 4055626001104
Weight per Piece (excluding packing) 550.000 g
Custom tariff number 85176200
Country of origin Taiwan
Technical data
Note
Utilization restriction EMC: class A product, see manufacturer's declaration in the download
area
Use in potentially explosive areas is not permitted in China.
Dimensions
Width 30 mm
Height 130 mm
Depth 100 mm
Ambient conditions
Degree of protection IP20
Ambient temperature (operation) -40 °C ... 75 °C
Ambient temperature (storage/transport) -40 °C ... 85 °C
Permissible humidity (operation) 5 % ... 95 % (non-condensing)
Air pressure (operation) 62 kPa ... 108 kPa (up to 4850 m above mean sea level)
Air pressure (storage/transport) 62 kPa ... 108 kPa (up to 4850 m above mean sea level)
Interfaces
Interface Ethernet (RJ45)
No. of ports 5 (RJ45 ports)
Note on the connection method Auto negotiation and autocrossing
Transmission physics Ethernet in RJ45 twisted pair
Transmission speed 10/100/1000 Mbps
Function
https://www.phoenixcontact.com/us/products/2891391
12/05/2020Page3/8
Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391
Technical data
Function
Basic functions Unmanaged switch / autonegotiation, complies with IEEE 802.3, store and
forward switching mode, includes QoS and alarm contact
Additional functions Autonegotiation
Jumbo frames (Max. 10,240 bytes)
PROFINET conformance class Conformance-Class A
Status and diagnostic indicators LEDs: US1, US2 (redundant voltage supply), link and activity per port
Network expansion parameters
Cascading depth Network, linear, and star structure: any
Maximum conductor length (twisted pair) 100 m
Supply voltage
Supply voltage 24 VDC (redundant)
Residual ripple 3.6 VPP (within the permitted voltage range)
Supply voltage range 10 VDC ... 60 VDC
Typical current consumption 223 mA (at US = 24 V DC)
Max. current consumption 547 mA (10 V DC)
Inrush current 7.2 A (400μs)
General
Mounting type DIN rail
Type AX Block design
Net weight 510.6 g
Housing material Aluminum
MTTF 121.4 Years (MIL-HDBK-217F standard, temperature 25°C, operating
cycle 100%)
Standards and Regulations
Electromagnetic compatibility Conformance with EMC Directive 2004/108/EC
Noise emission EN 61000-6-4
Noise immunity EN 61000-6-2:2005
Environmental Product Compliance
REACh SVHC Lead 7439-92-1
China RoHS Environmentally Friendly Use Period = 10;
For details about hazardous substances go to tab “Downloads”, Category
“Manufacturer's declaration”
Drawings
https://www.phoenixcontact.com/us/products/2891391
12/05/2020Page4/8
Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391
Connection diagram
US1 GND US2 GND R1 R2
+
–
+
–
Redundant power supply connection
Connection diagram
US1 GND US2 GND R1 R2
+
–
Single power supply connection
Classifications
eCl@ss
eCl@ss 10.0.1 19170402
eCl@ss 11.0 19170402
eCl@ss 5.0 19030100
eCl@ss 5.1 19030100
eCl@ss 6.0 19170100
eCl@ss 7.0 19170106
eCl@ss 8.0 19170106
eCl@ss 9.0 19170106
ETIM
ETIM 5.0 EC000734
ETIM 6.0 EC000734
ETIM 7.0 EC000734
UNSPSC
UNSPSC 13.2 43222612
UNSPSC 18.0 43222612
UNSPSC 19.0 43222612
UNSPSC 20.0 43222612
UNSPSC 21.0 43222612
Approvals
Approvals
https://www.phoenixcontact.com/us/products/2891391
12/05/2020Page5/8
Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391
Approvals
Approvals
UL Listed / cUL Listed / EAC / cULus Listed
Ex Approvals
UL Listed / cUL Listed / cULus Listed
Approval details
UL Listed http://database.ul.com/cgi-bin/XYV/template/LISEXT/1FRAME/index.htm FILE E 140324
cUL Listed http://database.ul.com/cgi-bin/XYV/template/LISEXT/1FRAME/index.htm FILE E 140324
EAC RU*-DE.*.B.00741/19
cULus Listed
Accessories
Accessories
Assembly adapter
Mounting plate-FL PA SFNT 5-8-2891012
Mounting plate for SFNT switches
Data cable preassembled
https://www.phoenixcontact.com/us/products/2891391
12/05/2020Page6/8
Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391
Accessories
Patch cable-NBC-R4AC-R4AC-IE8A/.../...-1411854
Patch cable, degree of protection: IP20, number of positions: 8, 10 Gbps, CAT6A, cable outlet: straight
Patch cable-NBC-R4AC/10G-R4AC/10G-94F/2,0-1408360
Patch cable, CAT6A, 4-pair, shielded, connection not crossed (line), assembled at both ends with RJ45/IP20 connectors,
outer sheath material: PUR, length: 2.0 m
Patch cable-NBC-R4AC/10G-R4AC/10G-94F/3,0-1408365
Patch cable, CAT6A, 4-pair, shielded, connection not crossed (line), assembled at both ends with RJ45/IP20 connectors,
outer sheath material: PUR, length: 3.0 m
End block
End clamp-E/NS 35 N-0800886
End clamp, width: 9.5 mm, color: gray
Mounting rail adapter
DIN rail adapter-FL DIN RA-2891053
The FL DIN RA is installed in a standard, 19-inch rack (EIA-310-D, IEC 60297-3-100) to allow DIN rail mounted
equipment to be rack mounted.
https://www.phoenixcontact.com/us/products/2891391
12/05/2020Page7/8
Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391
Accessories
Patch cable
Patch cable-FL CAT5 PATCH 0,5-2832263
Patch cable, CAT5, assembled, 0.5 m
Patch cable-FL CAT5 PATCH 1,0-2832276
Patch cable, CAT5, assembled, 1 m
Patch cable-FL CAT5 PATCH 2,0-2832289
Patch cable, CAT5, assembled, 2 m
PCB plug
Printed-circuit board connector-MSTB 2,5/ 3-ST-1754465
PCB connector, nominal cross section: 2.5 mm², color: green, nominal current: 12 A, rated voltage (III/2): 320 V, contact
surface: Tin, type of contact: Female connector, Number of potentials: 3, Number of rows: 1, Number of positions per
row: 3, number of connections: 3, product range: MSTB 2,5/..-ST, pitch: 5 mm, connection method: Screw connection
with tension sleeve, conductor/PCB connection direction: 0 °, Stecksystem: CLASSIC COMBICON, Locking: without,
type of packaging: packed in cardboard
Protective cap
https://www.phoenixcontact.com/us/products/2891391
12/05/2020Page8/8
Industrial Ethernet Switch-FL SWITCH SFNT 5GT-C-2891391
Accessories
Dust protection-FL RJ45 PROTECT CAP-2832991
Dust protection caps for RJ45 socket
Safety locking
Port Guard Security Element-FL SEC PAC 4TX-2832865
Layer1 security elements for four RJ45 network connections for use with patch boxes and panels
Surge protection for information technology
Surge protection device-DT-LAN-CAT.6+-2881007
Surge protection in accordance with Class EA (CAT6A), for Gigabit Ethernet (up to 10 Gbps), token ring, FDDI/CDDI,
ISDN, and DS1. Suitable for Power over Ethernet (PoE+) “Mode A” and “Mode B”. RJ45 attachment plug with separate
grounding cable and ground connection snap-on foot for NS 35 DIN rails.
Phoenix Contact 2020 © - all rights reserved
http://www.phoenixcontact.com
