Model Nominal
Voltage
Output Voltage
Float/Fast Charge
Output
Current
mA
Type
Automatic
Dimensions: in. (mm) Weight Charger
Design
Length Width Height lbs. kgs.
PSC-6300A-C 6 6.75 / 7.35 300 dual rate 2.05 (52) 1.57 (40) 2.64 (67) 0.21 0.10 Plug-in
PSC-6500A-C 6 6.75 / 7.35 500 dual rate 2.05 (52) 1.57 (40) 2.64 (67) 0.21 0.10 Plug-in
PSC-61000A-C 6 6.75 / 7.35 1000 dual rate 2.24 (57) 1.73 (44) 3.23 (82) 0.30 0.14 Plug-in
PSC-64000A-C 6 6.75 / 7.35 4000 dual rate 5.43 (138) 2.83 (72) 1.65 (42) 0.90 0.41 Desk Top
PSC-12300A-C 12 13.50 / 14.70 300 dual rate 2.05 (52) 1.57 (40) 2.64 (67) 0.21 0.10 Plug-in
PSC-12500A-C 12 13.50 / 14.70 500 dual rate 2.24 (57) 1.73 (44) 3.23 (82) 0.30 0.14 Plug-in
PSC-12800A-C 12 13.50 / 14.70 800 dual rate 2.24 (57) 1.73 (44) 3.23 (82) 0.30 0.14 Plug-in
PSC-122000A-C 12 13.50 / 14.70 1800 dual rate 5.43 (138) 2.83 (72) 1.65 (42) 0.90 0.41 Desk Top
PSC-124000A-C 12 13.50 / 14.70 4000 dual rate 5.43 (138) 2.83 (72) 1.65 (42) 0.90 0.41 Desk Top
PSC-1210000A-C* 12 13.50 / 14.70 10000 dual rate 8.80 (224) 5.17 (131) 3.33 (85) 4.30 1.95 Desk Top
PSC-241000A-C 24 27.00 / 29.40 1000 dual rate 5.43 (138) 2.83 (72) 1.65 (42) 0.90 0.41 Desk Top
We’ve Got The Power.™
Specications
Features Operating Characteristics
Note: All plug-in design have 39” (1m) leads. All desktop design have 59” (1.5m) input leads and 39” (1m) output leads.
• I.C. based voltage and current regulation designed for
sealed (valve-regulated) lead-acid batteries
• Useable on domestic and overseas input voltages
from 110VAC - 60Hz to 240VAC - 50Hz, except for the
PSC-1210000A-C, see charger selection guide
• Automatic, current sensing dual-rate charging for
efcient, care-free and safe operation
• L.E.D.s indicate ‘power on’ and “FAST” and “FLOAT”
charging modes
• Lightweight wall mounted plug-in or desk top design
with screw type output terminals, depending on output
current
• Connectors to the battery are alligator clips with
insulated sleeves
• Protected against accidental reverse polarity connection
• U.L. and European C.E. approval
“A-C” series chargers are new “switching” type devices
which operate without the use of transformers. I.C.’s control
and regulate current and voltage and automatically switch
from the higher fast charge voltage to the lower oat
voltage when batteries are very close to being fully charged.
At the oat voltage it is safe to leave the battery connected
to the charger indenitely, making charging pretty much
fool-proof.
In the fast charge mode voltage goes up to 2.45V +/- 0.05V
before switching, in the oat charge mode voltage is held
between 2.25- 2.30V/cell.
This charger is ideal for cyclic applications where recharge
time is critical and timely charge termination cannot
be counted on. This charger ensures optimum battery
performance & service life.
A-C SERIES SWITCH-MODE CHARGERS
FOR SLA BATTERIES
Recharge time depends on the depth of the preceding
discharge and the output current of the charger. To
determine the approximate recharge time of a fully
discharged battery, divide the battery’s amp. hrs. by
the rated output current of the charger and multiply
the resulting number of hours by a factor of 1.75 to
compensate for the declining output current during the
charge cycle. If the amount of amp. hrs. discharged
from the battery is known, use it instead of the battery’s
capacity to make the calculation.
To ensure safe and efcient operation always refer to
our Charger Operating Instructions, as published on our
website.
When charging batteries in series (positive terminal
of one battery is connected to negative of the other) all
batteries in the string will receive the same amount of
charge current, individual battery voltages may vary.
When charging batteries in parallel (positive terminals
are connected with positive terminals, negative terminals
with negative), all batteries in the string are subject to the
same charge voltage, but the charge current each battery
receives can and will vary until equalization is reached.
Notes
Charger Selection Guide
* Please note the PSC-1210000A-C is only available for use with input voltages of 90-132V 60 Hz. This charger is ideally suited for batteries from 40-100AH.
Charger Model Max Output (mA)
Use with Battery U.L./C.E.
Certied
Voltage Capacity
PSC-6300A-C 300 6 1-3 AH YES
PSC-6500A-C 500 6 2-5 AH YES
PSC-61000A-C 1000 6 5-10 AH YES
PSC-64000A-C 4000 6 10-40 AH YES
PSC-12300A-C 300 12 1-3 AH YES
PSC-12500A-C 500 12 2-5 AH YES
PSC-12800A-C 800 12 4-8 AH YES
PSC-122000A-C 1800 12 8-20 AH YES
PSC-124000A-C 4000 12 20-40 AH YES
PSC-1210000A-C* 10000 12 40-100 AH NO
PSC-241000A-C 1000 24 5-10 AH YES
Power-Sonic does not offer chargers for batteries with capacities higher than 100 AH. If you have any queries or
difculties in locating a suitable charger for batteries above 100AH, our Technical department will be happy to help.
CORPORATE OFFICE • 7550 Panasonic Way • San Diego, CA 92154 • USA • Tel: +1-619-661-2020 • Fax: +1-619-661-3650
CUSTOMER SERVICE
Tel: +1-619-661-2030
Fax: +1-619-661-3648
customer-service@power-sonic.com
INTERNATIONAL SALES
Tel: +1-650-364-5001
Fax: +1-650-366-3662
international-sales@power-sonic.com
DOMESTIC SALES
Tel: +1-619-661-2020
Fax: +1-619-661-3650
national-sales@power-sonic.com
TECHNICAL SUPPORT
Tel: +1-619-661-2020
Fax: +1-619-661-3648
support@power-sonic.com
Contact Information www.power-sonic.com
0812 1M
© 2012. Power-Sonic Corporation. All rights reserved. All trademarks are the property of their respective owners.
