FCP400-12G
© 2015 Bel Power Solutions, Inc.
+1.866.513.2839
tech.support@psbel.com
BCD.00141_AC
All specifications apply over specified input voltage, output load, and temperature range, unless otherwise noted.
Input Transient Protection
No-load and short circuit proof short circuit proof
overload (latch style)
Latch type – disable output V1
Overtemperature Protection
Automatic power shutdown at TA = 62 °C
All specifications apply over specified input voltage, output load, and temperature range, unless otherwise noted.
Reports information and monitors alarm functions
TTL compatible signal, open collector. Power supply enabled at Low or TTL "0"
(e.g. by connecting of pin 22 to 0V or GND)
AC Fail Warning (I2C & OC)*
Supervisory AC input voltage;
Supervisory under- and overvoltage pre-ORing FET of V1
Temperature Warning (I2C & OC)*
Indicates if unit is operating normally or in overtemperature,
Indicates if fan speed is below 80% of the currently required level
Active current share for V1
Droop load characteristic for V2
LEDs: DC OK (green), AC OK (green)
* Signal provided by I2C interface or by open collector (OC)
All specifications apply over specified input voltage, output load, and temperature range, unless otherwise noted.
Relative humidity, non-condensing
Relative humidity, non-condensing
IEC/EN 60068-2-6
2-8 Hz
8-200 Hz
200-500 Hz
MIL-HDBK-217F Notice 2, GB, 25 °C
The electric strength test is performed in the factory as routine test in accordance with EN50514, IEC/EN 60950, and UL 1950
and should not be repeated in the field. Bel Power Solutions will not honor any warranty claims resulting from electric strength
field tests.
Input/Case
Input/Output
Output/Case
Basic
Reinforced
Functional
Electric Strength Test Voltage
Input/Case
Input/Output
Output/Case
NOT RECOMMENDED FOR NEW DESIGN