We are happy to finally release Adafruit's lovely Raspberry Pi case, designed by Mike
Doell (who made our really terrific Arduino enclosures as well). We wanted a
beautiful, elegant case, not just functional but also something you'd really like having
on your desk. Gaze lovingly at its curves & its glossy clear cover!
Using this case is very easy and works with Raspberry Pi Model A, Model B rev 1 and
• Weight: 46.62g
• Dimensions: 68.4mm / 2.69" x 102.29mm / 4" x 24.18mm / 0.95"
Model B rev 2. Snap the Pi into the case bottom for a secure press-fit. If you want to
poke around you can leave the top cover off. If you want to protect your Pi, fit the
cover on, it will fit securely so you can put the Pi into your book-bag without worry.
There's a slot for a GPIO ribbon cable so you can connect a Pi Cobbler while the cover
is still on, and remove it easily as well by popping the top off. Please note: this case is
not compatible with our low-profile microSD card adapter.
The Pi is press-fit in the case so when removing the GPIO cable, make sure to either fully
remove the Pi or hold it down so it doesn't pop up.
Does not come with a Raspberry Pi or GPIO cable (but we do have them in the store,
so you can pick one up!)
Description
Technical Details
Adafruit Pi Case- Enclosure for Raspberry Pi Model A or B -
ID: 1326
