Ultra Fast Rectifiers multicomp Designed for use in switching power supplies inverters and as free wheeling diodes. These state-of-the-art devices have the following features: Switch mode Full Plastic Dual Schottky Barrier Power Rectifiers Features: High surge capacity. Low power loss, high efficiency. Glass passivated chip junctions. 150C operating junction temperature. Low stored charge majority carrier conduction. Low forward voltage, high current capability. High-switching speed 35 nanosecond recovery time. Plastic material used carries Underwriters Laboratory Flammability Classification 94V-O. 16 Amperes 200 Volts ITO-220AB Cc e) Jp a MILLIMETERS |* +! | |. aoe DIM min [MAX = 7 pt * A | 15.05 | 15.15 pe = B | 13.35 | 13.45 LS D of 7a c | 10.00 | 10.10 OO t + = D 6.55 | 6.65 4 E 265 | 2.75 F 1.55 | 1.65 G 1.15 | 1.25 H 0.55 | 0.65 ? p | 2.50 | 2.60 F + | A J 3.00 | 3.20 o, NM Kk | 1.10] 1.20 tl if 0.55 | 0.65 H a + M 4.40 4.60 +#] 4+) b+] Jo N 1.15 | 1.25 P 2.65 | 2.75 4 O 3.35 | 3.45 | \ T L Q 3.15 | 3.25 +| 4+ |+ | | + Dimensions : Millimetres 1 2 . Ho Common Cathode Part Number Table Description Part Number Ultra Fast Rectifiers MURF1620CT http://www. farnell.com http://www.newark.com http://www.cpc.co.uk Page <1> multicomp 27/12/10 V1.1Maximum Ratings Characteristic Symbol MURF1620 Units Peak Repetitive Reverse Voltage VrrRM Working Peak Reverse Voltage Vrwm 200 DC Blocking Voltage Vr V RMS Reverse Voltage Vr (RMS) 140 Average Rectifier Forward Current | 8.0 Total Device (Rated Vp), Tc = 55C F (AV) 16 Peak Repetitive Forward Current | 46 A (Rate Vp, Square Wave, 20kHz, Tc = 125C) FM Non-Repetitive Peak Surge Current (Surge applied at rate load | 150 conditions half-ware, single phase, 60Hz) ron Operating and Storage Junction Temperature Range Ty, Tstg -65 to +150 C Electrical Characteristics Characteristic Symbol MURF 1620 Units Maximum Instantaneous Forward Voltage (lz = 8.0 Amperes To = 25C) Ve 0.975 Vv (lz = 8.0 Amperes Tc = 125C) 0.850 Maximum Instantaneous Reverse Current (Rated DC Voltage, Tc = 25C) Ip 10.0 nA (Rated DC Voltage, Tc. = 125C) 200 Reverse Recovery Time (Ip = 0.5A, Ip = 1.0 I, = 0.25A) Tt oa hs Typical Junction Capacitance c (Reverse Voltage of 4 volts and f = 1 MHz) F 120 pF Page <2> 27/12/10 V1.1Typical Forward Characteristics 50 = o Average Forward Rectified Current (Amperes) a1 oO. 0.6 03 1.0 12 1.4 1.6 8 Forward Voltage (Volts) Typical Reverse Characteristics Instantaneous Reverse Current (uA) oO 20 40 60 6a 100 420 140 Percent of Rated Reverse Voltage (%) Peak Forward Surge Current 150 125 ~ 100 / wn o (Amperes) } { j bo un Peak Forward Surge Current ao = 10 100 Number of Cycles at 60 Hz Forward Current Derating Curve = mo = ba co Average Forward Rectified Current (Amperes) Oo 25 50 #5 100 125 150 Lead Temperature (C) Typical Junction Capacitance 500 100 Junction Capacitance (pF) = o = 5 10 50 100 Reverse Voltage (Volts) Page <3> 27/12/10 V1.1502 NI 102 NI the Ae WAS +0 Device (+) Under (-) L s0 de oa Pulse = Approximately Generator (-3 ie (Note 2) -0.25A $ Oscilloscope | + FN ote 1) | 8? -1.04 - Set time base for 10/20 ns/cm Reverse Recovery Time Characteristic and Test Circuit Diagram Notes: 1. Rise Time = 7 ns maximum input impedance = 1MQ, 22pF. 2. Rise Time = 10 ns maximum input impedance = 50Q. Disclaimer This data sheet and its contents (the "Information") belong to the Premier Farnell Group (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. SPC Multicomp is the registered trademark of the Group. Premier Farnell plc 2010. Page <4> 27/12/10 V1.1