EC centrifugal fans - RadiCal(R) Series R3G225 RE O225 mm 100...130 50/60 765.2 230 200...240 50/60 Watts RPM oC g Yes 170 2,870 -25...50 1,750 IP54 Yes Yes 170 2,860 -25...60 1,750 IP54 Yes UL 115 Ingress Protectin Rating 753.4 Mass R3G225-RE19-04 R3G225-RE07-03 Temperature range (1) VAC Speed (1) VAC Power input Voltage range CFM Ball bearings Nominal voltage Type Nominal Data Hertz Air flow Highlights: - Backward curved - 7-blade impeller, single phase motor - Output 10 VDC, max. 1.1 mA, Tach output, Control input 0-10 VDC / PWM - Motor current limit, Soft start, Locked-rotor protection, Over temperature protected electronics / motor - Mounting position: Any - Condensate discharge holes: None, open rotor - Ingress protection of IP54 Material: Fiberglass reinforced composite Impeller: PA6 Direction of rotation: Clockwise, seen on rotor (1) Nominal data at maximum load. Curves R3G225-RE19-04 Curves Druck p f s[Pa]fur Rho=1,2kg/m^3 200 300 400 qv[cfm] 500 600 700 800 3,1 3 2,9 2,8 2,7 2,6 2,5 2,4 2,3 4 2,2 2,1 2 1,9 8 1,8 1,7 3 1,6 1,5 7 1,4 1,3 12 1,2 1,1 1 11 0,9 2 16 0,8 6 15 0,7 0,6 10 0,5 0,4 14 0,3 100 200 300 400 500 600 700 800 qv[m^3/h] 900 1.000 5 1.100 1.200 0,2 ] [Pa pfs 0 9 ] [Pa pfs 13 ] [Pa pfs ] [Pa pfs 760 740 720 700 680 660 640 620 600 580 560 540 520 500 480 460 440 420 400 380 360 340 320 300 280 260 240 220 200 180 160 140 120 100 80 60 40 20 0 100 0,1 1 1.300 1.400 0 p fs_E[IN H2O] pf s[Pa] 0 I A n Pe rpm W (115V) dB(A) LwA Measurement: LU-142355 A 1 2985 153 1.99 78 Air performance measured as per: ISO 5801, Installation category A, without protection against accidental contact. A 2 2870 170 2.20 74 A 3 2895 162 2.09 68 A 4 2965 150 1.95 73 Suction-side noise levels: LWA as per ISO 13347, LPA measured at 1m distance to fan axis. A 5 2500 90 1.17 75 A 6 2500 113 1.45 70 A 7 2500 104 1.34 66 The values given are valid under the measuring conditions mentioned and may vary accoring to the actual installation situation. A 8 2500 90 1.17 69 A 9 2000 46 0.60 69 A 10 2000 58 0.74 65 A 11 2000 53 0.69 61 A 12 2000 46 0.60 63 A 13 1500 19 0.25 63 A 14 1500 25 0.31 59 A 15 1500 23 0.29 55 A 16 1500 19 0.25 57 With any deviation to the standard set-up, the specific values have to be checked and reviewed once installed or fitted. For detailed information on the measuring set-up, please contact ebm-papst. R3G225-RE07-03 Curves Pe rpm W (230V) dB(A) 200 300 400 qv[cfm] 500 600 700 800 3,1 3 2,9 2,8 2,7 2,6 2,5 2,4 2,3 4 2,2 2,1 2 1,9 8 1,8 1,7 3 1,6 1,5 7 1,4 1,3 12 1,2 1,1 1 11 0,9 2 16 0,8 6 15 0,7 0,6 10 0,5 0,4 14 0,3 100 200 300 400 500 600 700 800 qv[m^3/h] 9 900 5 1.000 1.100 1.200 0,2 ] [Pa pf s 0 Pa] pf s[ 13 ] [Pa pf s ] [Pa pf s 780 760 740 720 700 680 660 640 620 600 580 560 540 520 500 480 460 440 420 400 380 360 340 320 300 280 260 240 220 200 180 160 140 120 100 80 60 40 20 0 100 p fs_E[IN H2O] pf s[Pa] Druck p f s[Pa]fur Rho=1,2kg/m^3 0 0,1 1 1.300 1.400 0 1.500 A B 1 3030 151 1.25 78 Air performance measured as per: ISO 5801, Installation category A, without protection against accidental contact. A B 2 2910 168 1.40 74 A B 3 2860 170 1.40 68 A B 4 2970 157 1.35 73 Suction-side noise levels: LWA as per ISO 13347, LPA measured at 1m distance to fan axis. A B 5 2700 107 0.89 76 A B 6 2700 134 1.11 72 A B 7 2700 135 1.15 67 The values given are valid under the measuring conditions mentioned and may vary accoring to the actual installation situation. A B 8 2700 118 1.01 70 A B 9 2200 58 0.48 70 A B 10 2200 73 0.60 67 A B 11 2200 73 0.62 62 A B 12 2200 64 0.55 65 A B 13 1700 27 0.22 64 A B 14 1700 33 0.28 61 A B 15 1700 34 0.29 56 A B 16 1700 29 0.25 59 With any deviation to the standard set-up, the specific values have to be checked and reviewed once installed or fitted. For detailed information on the measuring set-up, please contact ebm-papst. O0.18(4.5) 4X Depth of screw max. 10mm Depth of screw max. 5mm 24 5 +10) (6 ) (8 0. 3. 35 17 .7 2( 45 0 +2 0 ) O8.78(223) O8.57 (210) O5.75 (146) O8.86 (225) O6.04(153.5+0.2) O2.83 (72) O2.95 (75) O3.98(101) 0.20 (5) 2.28 (58 +0.2) 0.06 (1.5) 1.10 (28) 3.90 (99) 0.08 (2) LwA Measurement: LU-129100 R3G225-REXX-XX 3.48 (88.4) I A n Accessory part: Inlet nozzle 96358-2-4013, not included in the standard scope of delivery 3.54 (90 +0.2) Connection line PVC 4X AWG20; 4 x brass lead tips crimped Connection line PVC 3G AWG20; 3 x brass lead tips crimped A 1 A 2 A 3 A 4 A 5 A 6 A 7 A 8 A 9 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: ebm-papst: R3G225-RE19-04 R3G225-RE07-03