© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 (864) 963-6300 • www.kemet.com
Product Bulletin
Dimensions – Millimeters (Inches)
EIA Size
Code
Metric Size
Code
L
Length
W
Width
B
Bandwidth
S
Separation
1210 3225 3.2 (.126)
± 0.20 (.008) 2.5 (.098)
± 0.20 (.008) 0.50 (.02)
± 0.25 (.010) N/A
See below for thickness dimension.
Capacitance Value
Capacitance
Values (μF)
KEMET Part
Number Voltage Capacitance
Tolerance
Thickness
mm
Qty
7” Reel
Qty
13” Reel
4.7 C1210C475(1)5RAC 50 K,M 2.5 (.098) ± 0.10 (.004) 1,000 4,000
6.8 C1210C685(1)3RAC 25 K,M 1.7 (.067) ± 0.20 (.008) 2,000 8,000
10.0 C1210C106(1)3RAC 25 K,M 2.5 (.098) ± 0.10 (.004) 1,000 4,000
Outline Drawing
WL
B
S
T
CONDUCTIVE METALLIZATIONELECTRODES
TIN PLATE
NICKEL PLATE
F-9125 2/07
Surface Mount Ceramic Chip Capacitors – X7R Dielectric
As detailed in the KEMET Surface Mount Catalog F3102 for X7R, with following specific requirement s based on room
temperature (25°C) parameters:
• Operating Range: -55°C to +125°C, with no-bias capacitance shift limited to ± 15% over that range.
• Insulation Resistance (IR) measured after 2 minutes at rated voltage @ 25°C: Limit is 500 megohm microfarads or
10GΩ, whichever of the two is smaller.
• Capacitance and Dissipation Factor (DF) measured at the following conditions. 1 kHz and 1 Vrms.
DF Limits for 50V product is 2.5% and for 25V product is 3.5%.
These components are suitable for reflow and wave soldering. All parts incorporate the standard KEMET barrier layer
of pure nickel, with an overplate of pure tin to provide excellent solderability as well as resistance to leaching.
These chips will be supplied unmarked. However, marking is available as an extra cost option.
AEC-Q200 Rev. C - Automotive
RoHS 5 - SnPb termination
RoHS 6 - 100% tin termination
In general, the information in the KEMET Surface Mount catalog F3102 applies to these capacitors. The
information in this bulletin supplements that in the catalog.
(1) Insert capacitance tolerance K for ±10% or M for ±20%.
These components are also available with SnPb plated nickel barrier terminations as a option.
Electrical Parameters
Soldering Process
Marking
Qualification/Certification
