Available on Tape
and Reel For Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
(315) 432-89 09
(800) 544-24 14
+44 2392-232392
Model H100N
A
30X4
Features:
• DC –2.7 GHz
• 100 Watts
• AlN Ceramic
• Non-Nichrome Resistive
Element
• Low VSWR
• Welded Silver Leads
• 100% Tested
• RoHS Compliant
ATTENUATOR
FULL FLANGE
100 Watts
General Specifications
Resistive Element Thick film
Substrate ALN ceramic
Cover Alumina Ceramic
Mounting Flange Copper, Nickel plated per QQ-N-290
Lead(s): 99.99% pure silver (.006” thick)
Electrical Specifications
Attenuation Range: 30 dB ±2.5 dB to 2.7 GHz
Frequency Range; DC – 2.7 GHz
Power: 100 Watts
VSWR: 24 dB to 2.2 GHz
20 dB to 2.7 GHz
Note: Tolerance is
±
0.010”, unless otherwise specified. Designed to meet of
exceed applicable portions of MIL-E-5400. Operating temperature is -55ºC to
150ºC (see chart for derating temperatures).
All dimensions in inches.
Specifications subject to change wi th out notice.
Outline Drawing
UNLESS OTHERWISE SPECIFIED LEAD LENGTH IS 0.150” MINIMUM H100NA30X4 (097) Rev D
RoHS
Compliant
USA/Canada:
Toll Free:
Europe:
(315) 432-8909
(800) 544-2414
+44 2392-232392
Available on Tape and
Reel For Pick and Place
Manufacturing.
Model H100NA30X4
Typical Performance:
Power De-rating: Mounting Footprint and Procedure:
NOT RECOMMENDED APPLICATION
BOARD LO W ER
THAN LEAD. THAN LEAD.
BOARD HIGH ER
SCALE: NONESCALE: NONE
BOARD EVEN
WITH LEAD.THAN LEAD.
BOARD LO W ER
SUGGESTED STRESS RELIEF METHODS
(2 PLACES)
.025 MIN.
SUGGESTED MOUNTING PROCEDURES:
1. MAKE SURE THAT THE DEVICES ARE MOUNTED ON
FLAT SURFACES (.001" UNDER THE DEVICE) TO
OPTIMIZE THE HEAT TRANSFER.
DRILL & TAP THE HEATSINK FOR THE APPROPR IATE2. THREAD SIZE TO BE USED.
3. COAT HEATSINK WITH A MINIMUM AMOUNT OF HIGH
QUALITY SILICONE GREASE (.001" MAX. THICKNESS).
4. POSITION DEVICE ON MOUNTING SURFACE & SECURE
USING SOCKET HEAD SCREWS, FLAT & SPLIT WASHER.
TORQUE SCREWS TO THE APPROPRI ATE VALUE. MAKE
5.
SURE THAT THE DEVICE IS FLAT AGAINST THE HEATSINK.
(CARE SHOULD BE TAKEN TO AVOID UPWARD PRESSURE OF
THE LEADS TOWARDS THE LID).
SOLDER LEADS IN PLACE USING APPROPROATE SOLDER WITH
A CONTROLLED TEMPERATURE IRON.
** FOR MORE DETAILS CONTACT FACTORY **
H100NA20X4 (097) Rev D
