2-21
Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com
2
2mm Round
®
OptopipeTM
Optical Light Pipe, 2 Array
(MT-ODE Jack)
515-1090
Dimensions in mm [inches]
Recommended
MicroLED SMT LEDs
for use with 515-1090
PART NO. PAGE #
597-3xx1-5xx 1-30
597-77x1-5xx 1-31
Solder Pad/Holes layout shown is for bi-color
LEDs
Contact factory for single color layout
Features
• High transmissivity polycarbonate material
• UL94V-0 compliance
• ESD protection (circuit isolation from front panel)
• Wide viewing angle
• Arrays reduce insertion costs
• Secures to PCB by press-fit
LED Data
For absolute maximum ratings and other electrical and optical
data on the recommended LEDs, refer to LED data sheets.
Dialight
Optopipe
Light Pipe Description
This bright, 2 element Optopipe™ is designed to reach over the top of circuit board components with a maximum
height of 0.399". The central cross bar acts as a standoff which gives additional support when resting the pipe on top of a
component. This Optopipe™ is designed to allow arrays to be laid out with the SMT LEDs on a continuous 0.228" pitch.
The recommended light sources are Dialight's 597 Series 1208 or 1210 Type SMT LEDs. The Optopipe™ material is
water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom Optopipe™ solutions for your applications.
Operating/Storage Temperature
–30°C to +100°C
NOTE: designed for
post-reflow
PC board insertion.
NEW