Designed for use in switching power supplies inverters and as free wheeling diodes. These state-of-the-art devices have the following features: Switch mode Dual Ultrafast Power Rectifiers Features: Glass passivated chip junctions. Low reverse leakage current. Fast switching for high efficiency. 150C operating junction temperature. Low stored charge majority carrier conduction. Low forward voltage, high current capability. Plastic material used carries Underwriters Laboratory Flammability classification 94V-O. 30 Amperes 200 Volts TO-3P pm [MILLIMETERS B MIN | MAX A | 20.63 | 22.38 0 rm ps =| M\~ B | 15.38 | 16.20 Lt S| a) an DD ef \. E | 14.81 | 15.22 1 1 E F | 114.72 | 12.84 F G | 420] 4.50 1 23 H | 182] 246 6G N | 292 | 3.23 H 1 Ze LS J 0.89 | 1.53 oo kL. K 5.26 | 5.66 L | 1850 | 21.50 mM | 468] 5.36 fF Ll N | 240] 2.80 P o | 325] 3.65 a IK 5 P 0.55 | 0.70 Dimensions : Millimetres 1 2 % or Ke Common Cathode Part Number Table Description Part Number | Ultra Fast Rectifiers MUR3020WT | Page <1> 27/12/10 V1.1Maximum Ratings (Reverse Voltage of 4 volts and f = 1 MHz) Characteristic Symbol MUR3020WT Units Peak Repetitive Reverse Voltage VrRM Working Peak Reverse Voltage Verwo 200 DC Blocking Voltage Ve Vv RMS Reverse Voltage VR (RMS) 140 Average Rectifier Forward Current Per Leg IF (AV) 15 Per Total Device 30 Peak Repetitive Forward Current | 30 A (Rate Vp, Square Wave, 20kHz) FM Non-Repetitive Peak Surge Current | 300 (Surge applied at rate load conditions half-ware, single phase, 60Hz) oan Operating and Storage Junction Temperature Range Ty: Tstg -65 to +150 "CS Electrical Characteristics Characteristic Symbol MUR3020WT Units Maximum Instantaneous Forward Voltage (lp = 15 Amperes T, = 25C) Ve 0.975 V (lp = 15 Amperes T, = 125C) 0.880 Maximum Instantaneous Reverse Current (Rated DC Voltage, Tg = 25C) Ip 10 pA (Rated DC Voltage, Tc = 150C) 500 Reverse Recovery Time (Ip = 0.5A, Ip = 1.0 I, = 0.25A) Tr 35 ns Typical Junction Capacitance Cp 250 pF Page <2> 27/12/10 V1.1Typical Forward Characteristics 100 n o Average Forward Rectified Current (Amperes) n 0.6 0.8 1.0 1.2 1.4 1.6 1.8 Forward Voltage (Volts) Typical Reverse Characteristics Instantaneous Reverse Current (HA) 0 20 40 60 80 100 120 Percent of Rated Reverse Voltage (%) Peak Forward Surge Current 300 - 250 200 150 - (Amperes) 100 50 Peak Forward Surge Current 1 10 100 Number of Cycles at 60 Hz 140 Average Forward Rectified Current (Amperes) Junction Capacitance (pF) Nw WwW a oo nl 15> $e +4. = \ Forward Current Derating Curve 4 \ 5+ a. 0 26 50 75 100 125 150 Lead Temperature (C) Typical Junction Capacitance 1000 600 100 10 1 5 10 50 100 Reverse Voltage (Volts) Page <3> 27/12/10 V1.1Device Under (-) Pulse Generator (Note 2) Oscilloscope (+) (Nate 1} Set time base for 10/20 ns/cm Reverse Recovery Time Characteristic and Test Circuit Diagram Notes: 1. Rise Time = 7 ns maximum input impedance = 1MQ, 22pF. 2. Rise Time = 10 ns maximum input impedance = 50Q. Disclaimer Sree eee sine Grid Be Coates fe Information") belong Fe antiein sy np! op a pie eeepc serpin fmar had pl nc pg in connection with to which trelates.Nojeance of any halt isis area. The he formation subject to change witht notice and all data sheets previously previously Suppead The Information Rese ha He cea ne SSOmTFestines Evry Tix BOF] Orrpessioe] FTPNTT IEDC oe ceton Listimny for toon data see Se Chee the Information and the suita ie purpose an nt make ay asumplons based on rman panty Oe eco carey? eon ahha aa ny la nlf rps Bad where the Group was aware th possi of such oss damage arin) excluded. fom ary rlance'on the, tamaton or ure of pct abit resuing fom ne Tagligence: SPC. Musicornn is ite regetered mademark of tie Group. Prem F. pic 2010, Page <4> 27/12/10 V1.1