www.switches-sensors.zf.com
Page 1 of 2, last update 2016-07-06, Specifications subject to change without notice.
Angle Position Sensors
AN8 Sensors
Programmable, non-contact magnetic position
sensors capable of continuous rotation
Description
The AN8 Series sensors are non-contact, intrinsically linear angle position sensors. The sensors operate through the use of Hall
Effect technology with magnetic fields generated by permanent magnets. They provide a linear change in voltage output
(ratiometric to the input voltage) corresponding to an angular rotation of the input shaft.
Angular position sensor with high tolerance for misalignment
Non-contact angular position sensing and full 360° rotation
Custom programming available for: angle range, slope, PWM
output, custom magnets – contact factory
No mechanical interface means no parts to wear out or jam
Available with Delphi connector or 12” (305 mm) wire leads
RoHS compliant
IP67
Maximum air gap of 5.5 mm (0.22”)*
Implement (fork lift, agricultural trailer hitch,
etc.) position sensing
Steer, throttle by wire
Gear selection
Zero-contact encoder alternative
Replacement for smart bearings
Outboard trim sensing
Environmental Specifications
6g sinusoidal, 8 g RMS axial; 40Hz – 2 kHz all 3 axes
-40 °C to 125 °C (-40 °F to 257 °F) with Delphi connectors,
-40 °C to 150 °C (-40 °F to 302 °F) with wire leads
-40 °C to 150 °C (-40 °F to 302 °F)
Electrical Specifications
10% to 90% of input (see graph for voltage vs. rotation angle
characteristics)
Absolute Max. Output Current
Mechanical Specifications
Delphi Metri-pak 150.2 12162185; Terminal 1214075 / 2047680
Maximum Air Gap*
*with AS500106 magnet carrier
Maximum Center-To-Center Offset
2 mm radial (magnet to center)