PCB Horizontal Mounting Features: * * rocess sealed - withstands machine soldering and pressure P wash processes Epoxy sealed terminations Specifications: Contact Configuration Switch Operation Contact Current Max Switch Terminals Contact Voltage Actuator Style Switch Mounting Contact Plating No. of Poles Electrical Life Contact Resistance Insulation Resistance Dielectric Strength Operating Temperature : DPDT : On-Off-On : 100mA : Through Hole : 20V : Bat : PCB : Gold :1 : 50,000 make-and-break cycles at full load :2 0m max. initial at 2V - 4V DC 100mA for both silver and gold plated contacts : 1,000M min. : 1,000V RMS at sea level : -30C to +85C Materials: Case and Bushing Actuator Switch Support Terminal/Contact : Glass filled nylon 6/6, retardant, heat stabilized :B rass, Chrome plated. Internal O-ring seal, standard for all actuators : Brass, Tin plated : Silver or gold plated Rating: R Q :0 .4 Volt-Amp (VA) max. at 20V max. (AC or DC) :1 Amp at 250V AC 3 Amp at 120V AC or 28V DC www.element14.com www.farnell.com www.newark.com Page <1> 03/10/12 V1.0 PCB Horizontal Mounting Subminiature, Washable P.C. Mounting Dimensions : Millimetres (Inches) Switch Function Position 1 Terminal Common Position 2 2-3, 5-6 SCHEMATIC Position 3 2-1, 5-4 OPEN Part Number Table Description Switch Operation Part Number Switch, PCB, DPDT, Horiz DPDT on-off-on 2AD3T2A2M6RE Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. (c) Premier Farnell plc 2012. www.element14.com www.farnell.com www.newark.com Page <2> 03/10/12 V1.0