Si5xx5x7-EVB E VALUATION B OA RD F O R Si53 X /55 X /59 X X O S /VCXO S Description Features This document describes the operation of the Silicon Laboratories Si5xx5x7-EVB evaluation board to evaluate both Silicon Laboratories' Si55x and Si595 VCXOs and Si53x and Si590/591 XOs. The Si53x/55x/ 59x devices use Silicon Laboratories' advanced DSPLL(R) circuitry to provide a low-jitter clock at high frequencies. The Si55x/Si53x/59x IC-based device is factory configurable for a wide variety of user specifications including frequency, supply voltage, output, and tuning slope. Specific configurations are factory programmed into the Si55x/Si53x/59x at time of shipment, thereby eliminating the long lead times associated with custom oscillators. Si55x/Si53x/59x samples should be ordered at the same time as the Si5xx5x7-EVB since the EVB does not come with the device. This allows end users maximum flexibility. Silicon Laboratories can solder down samples when ordering an EVB; please specify when ordering. Evaluation of Silicon Laboratories' Si55x/53x/59x family AC-coupled differential output clocks Voltage control (VC) input port (for Si55x/595 devices) Jumper selection for multi-frequency outputs Jumper selection for output enable Functional Block Diagram Power Input Configuration Jumpers VC Input Rev. 0.3 8/09 RC Filter (no-pop) Si5xx Device CLK+ Output Bias Copyright (c) by 2009 Silicon Laboratories DC Block CLK- Si5xx5x7-EVB Si5xx5x7-EVB 1. Functional Description 1.1. Power Supply The Si5xx5x7-EVB provides access to all signals for configuring and operating the device. This board allows evaluation of the Si55x/595 VCXO device either by itself (open-loop) or within a prototype PLL (closed-loop). The performance of the Si53x/590/591 XO device can also be evaluated on this board (the Vc port is not used for XO devices). Table 1. Jumper Control Part Type JP1 JP2 JP3 JP4 Si530 N/A N/A OE N/A Si531 N/A N/A N/A OE Si532 N/A N/A OE Freq Sel Si533 N/A N/A Freq Sel OE OE N/A Si534 Freq Sel1 Freq Sel2 Si550 N/A N/A OE VC Si552 N/A N/A Freq Sel VC OE VC Si554 Freq Sel1 Freq Sel2 Si590 N/A N/A OE N/A Si591 N/A N/A N/A OE Si595 N/A N/A OE VC The Si55x/Si53x/59x devices support operation from nominal voltages of 1.8, 2.5, and 3.3 V. Review the device data sheet and part number for allowed configurations of output buffer type and device power supply. 1.2. Voltage Control for VCXOs The voltage control (VC) input of the Si55x/595 device is conveniently accessible through an SMA jack (J3) but can also be driven (and observed) through 100 milcentered posts (JP4). For prototyping purposes, two 0603 solder pads are located near the device VC input (R3 and C3). A traditional PLL might use these as a single-time-constant low-pass filter (RC filter). The EVB is shipped with a 0 resistor soldered at R3; C3 is left open. The voltage control input is not used for XO devices. 1.3. Output Clock Notes: 1. With jumper(s) installed, signal(s) are driven low. 2. With jumper(s) not installed, signal(s) are pulled high. Because the Si55x/Si53x/59x devices can support an LVPECL buffer type (in addition to LVDS and CMOS), pulldown resistors (R1 and R2) are available for proper output biasing. For LVPECL buffers, biasing can be achieved through a variety of equivalent circuits; the Si5xx5x7-EVB allows for 130 pulldown resistors. After the output biasing, the high-speed outputs are dcblocked for connection to differently biased inputs, such as standard test equipment or a phase detector EVB. Please review "1.4. Preparing the EVB" for non-LVPECL devices. 1.4. Preparing the EVB By default, the evaluation board is set up to accept LVPECL configured devices. This configuration uses 130 pull-down resistors to bias the LVPECL output stage. If an LVDS, CMOS, or CML based device is to be installed, the output biasing resistors, R1 and R2, should be removed. 2 Rev. 0.3 Rev. 0.3 JP4 POS2 POS1 2 1 VDD C6 DNS C3 DNS High-order pole 0 R3 MKDSN 2,5/3-5,08 J4 C5 DNS Alternate Vc input Place in-line with J3 Vc input J3 SMA EVB Power Input C4 DNS F2 F1 VC OE OE 8 7 1 2 Si550 U1 VDD JP3 4 5 DNS DNS JP2 JP1 R2 R1 Figure 1. Si5xx5x7-EVB Schematic Frequency Select F2 F1 CLKOUT- CLKOUT+ Silicon Labs VCXO Output Enable F2 F1 OE DNC 9 6 VDD GND 3 VDD 0.1uF C2 0.1uF C1 SMA J2 SMA J1 Main output; route as differential pair Si5xx5x7-EVB 2. Schematics 3 Si5xx5x7-EVB 3. Bill of Materials Table 2. Si5xx5x7-EVB Bill of Materials Item Qty Ref Description Mfr # Mfr 1 2 C1,C2 CAP,SM,0.1 F, 16 V,20%,X7R,0402 C0402X7R160-104KNE Venkel 2 2 C5 CAP,SM,0.1 F, 16 V,20%,X7R,0603 C0603X7R160-104KNE Venkel 3 1 C4 CAP,SM,10 F, 10 V,10%,TANTALUM,3216 TA010TCM106KAR Venkel 4 1 C6 CAP,SM,100 pF, 50 V,10%,C0G,0603 C0603C0G500-101KNE Venkel 5 4 JP1,JP2, JP3,JP4 CONN,HEADER,2X1 TSW-150-07-T-D or TSW-150-07-T-S Samtec 6 3 J1,J2,J3 CONN,SMA SIDE MOUNT 901-10003 Amphenol 7 1 J4 CONN,POWER, 2 POSITION 1729018 Phoenix Contact 8 1 R3 RES,SM,0 ,0603 CR0603-16W-000T Venkel 9 2 R1,R2 RES,SM,150,1%,0603 CR0603-16W-1500FT Venkel 11 1 C3 CAP,SM,0.1 F, 16 V,20%,X7R,0603 C0603X7R160-104KNE Venkel 10 1 U1 Si5xx - Not populated Si5xx Silicon Laboratories No Load 4 Rev. 0.3 Si5xx5x7-EVB 4. Layout Figure 2. Assembly Drawing Figure 3. Layer 1 Primary Figure 4. Layer 2 Secondary Rev. 0.3 5 Si5xx5x7-EVB DOCUMENT CHANGE LIST Revision 0.13 to Revision 0.14 Updated "Bill of Materials" on page 4. Updated Figure 2, "Assembly Drawing," on page 5. Revision 0.14 to Revision 0.2 Changed Si5xx-EVB to Si5xx5x7-EVB. Revision 0.2 to Revision 0.3 Changed instances of Si53x/590/591, Si55x, and Si53x to Si53x/55x/59x throughout. Updated Table 1, "Jumper Control," on page 2. 6 Rev. 0.3 Si5xx5x7-EVB NOTES: Rev. 0.3 7 ClockBuilder Pro One-click access to Timing tools, documentation, software, source code libraries & more. Available for Windows and iOS (CBGo only). www.silabs.com/CBPro Timing Portfolio www.silabs.com/timing SW/HW Quality Support and Community www.silabs.com/CBPro www.silabs.com/quality community.silabs.com Disclaimer Silicon Laboratories intends to provide customers with the latest, accurate, and in-depth documentation of all peripherals and modules available for system and software implementers using or intending to use the Silicon Laboratories products. Characterization data, available modules and peripherals, memory sizes and memory addresses refer to each specific device, and "Typical" parameters provided can and do vary in different applications. Application examples described herein are for illustrative purposes only. Silicon Laboratories reserves the right to make changes without further notice and limitation to product information, specifications, and descriptions herein, and does not give warranties as to the accuracy or completeness of the included information. Silicon Laboratories shall have no liability for the consequences of use of the information supplied herein. This document does not imply or express copyright licenses granted hereunder to design or fabricate any integrated circuits. The products must not be used within any Life Support System without the specific written consent of Silicon Laboratories. A "Life Support System" is any product or system intended to support or sustain life and/or health, which, if it fails, can be reasonably expected to result in significant personal injury or death. Silicon Laboratories products are generally not intended for military applications. Silicon Laboratories products shall under no circumstances be used in weapons of mass destruction including (but not limited to) nuclear, biological or chemical weapons, or missiles capable of delivering such weapons. Trademark Information Silicon Laboratories Inc., Silicon Laboratories, Silicon Labs, SiLabs and the Silicon Labs logo, CMEMS(R), EFM, EFM32, EFR, Energy Micro, Energy Micro logo and combinations thereof, "the world's most energy friendly microcontrollers", Ember(R), EZLink(R), EZMac(R), EZRadio(R), EZRadioPRO(R), DSPLL(R), ISOmodem (R), Precision32(R), ProSLIC(R), SiPHY(R), USBXpress(R) and others are trademarks or registered trademarks of Silicon Laboratories Inc. ARM, CORTEX, Cortex-M3 and THUMB are trademarks or registered trademarks of ARM Holdings. Keil is a registered trademark of ARM Limited. All other products or brand names mentioned herein are trademarks of their respective holders. Silicon Laboratories Inc. 400 West Cesar Chavez Austin, TX 78701 USA http://www.silabs.com Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Silicon Laboratories: Si5XX5X7-EVB SI5XX5X7-EVB