ROHS Compliant Model K100N50X4 Half Flange Termination 100 Watts, 50 Description The K100N50X4 is high performance Aluminum Nitride (AlN) half flange termination intended as a cost competitive alternative to Beryllium Oxide (BeO). The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating circulators, and for use in power combiners. The termination is also RoHS compliant! General Specifications Thick Film AlN Ceramic Alumina Ceramic Copper, nickel plated per QC-N-290 99% pure silver (.006" thick) * RoHS Compliant Resistive Element Substrate Cover Mounting Flange Leads * 100 Watts Tolerance is 0.010", unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Features: * DC - 3.0 GHz * AlN Ceramic * Non-Nichrome Resistive Element * Low VSWR * 100% Tested Electrical Specifications Resistance Value: Power: Frequency Range: V.S.W.R. 50 Ohms, 2% 100 Watts DC - 3.0GHz 1.25 : 1 Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Storage temperature is -20C to 85 C . Operating temperature is -55C to 125C (see chart for derating temperatures). Specifications subject to change with out notice. Outline Drawing Note: All dimensions in inches - 1inch = 2.54cm. Lead Length: 0.150in min. K100N50X4 (097) Rev D. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model K100N50X4 ROHS Compliant Typical Performance: Power De-rating: Mounting Footprint and Procedure: K100N50X4 (097) Rev D USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392