SURFACE MOUNT DISPLAY Part Number: KCDA02-101 High Efficiency Red Features Description z 0.2 INCH DIGIT HEIGHT. The High Efficiency Red source color devices are made with z LOW CURRENT OPERATION. Gallium Arsenide Phosphide on Gallium Phosphide Orange z EXCELLENT CHARACTER APPEARANCE. Light Emitting Diode. z I.C. COMPATIBLE. z MECHANICALLY RUGGED. z PACKAGE :300PCS / REEL. z GRAY FACE, WHITE SEGMENT. z MOISTURE SENSITIVITY LEVEL : LEVEL 4. z RoHS COMPLIANT. Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. 3.The gap between the reflector and PCB shall not exceed 0.25mm. SPEC NO: DSAG1132 REV NO: V.6 DATE: AUG/29/2007 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: S.J.Liu PAGE: 1 OF 4 ERP: 1352000355 Selection Guide Part No. Dice KCDA02-101 Lens Type High Efficiency Red (GaAsP/GaP) WHITE DIFFUSED Iv (ucd) [1] @ 10mA Description Min. Typ. 1200 5800 Common Anode, Rt. Hand Decimal. Note: 1. Luminous intensity/ luminous Flux: +/-15%. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. peak Peak Wavelength High Efficiency Red D [1] Dominant Wavelength 1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF [2] Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR=5V Notes: 1.Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. Absolute Maximum Ratings at TA=25C Parameter High Efficiency Red Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating / Storage Temperature -40C To +85C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAG1132 REV NO: V.6 DATE: AUG/29/2007 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: S.J.Liu PAGE: 2 OF 4 ERP: 1352000355 High Efficiency Red KCDA02-101 SPEC NO: DSAG1132 REV NO: V.6 DATE: AUG/29/2007 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: S.J.Liu PAGE: 3 OF 4 ERP: 1352000355 KCDA02-101 Recommended Soldering Pattern (Units : mm; Tolerance: 0.15) Tape Specifications (Units : mm) SPEC NO: DSAG1132 REV NO: V.6 DATE: AUG/29/2007 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: S.J.Liu PAGE: 4 OF 4 ERP: 1352000355