140 MHz SAW Bandpass Filter
72 MHz bandwidth
Part Number SF0140BA02393S
Integrated
Circuit
Systems, Inc.
Rev X3 20-Apr-05
Page 1 of 2
Integrated Circuit Systems • Surface Acoustic Wave Products
TYPICAL PERFORMANCE
Horizontal: 20 MHz/div Vertical (from top): Magnitude 10 dB/div
Magnitude 1 dB/div
Phase Linearity 5 deg/div
SPECIFICATION
Parameter 1Min. Typ. Max. Units.
Center Frequency ( Fc) 2 140 MHz
Insertion Loss at 140 MHz 3 22.5 dB
Lower 1.5 dB Band Edge
Upper 1.5 dB Band Edge
171.00 109.00
MHz
MHz
Lower 3 dB Band Edge
Upper 3 dB Band edge
176.00 104.00
MHz
MHz
Lower 35 dB Band edge
Upper 35 dB band Edge
92.00
187.00
MHz
MHz
Amplitude Variation (109-171 MHz)) 1.5 dB p-p
Phase Linearity (109-171 MHz) 10 deg p-p
Group Delay Variation (109-171 MHz) 100 ns p-p
Rejection (15 to 75 MHz)
(75 to 89 MHz)
(193 to 215 MHz)
(215 to 298 MHz)
45
40
40
40
dB
dB
dB
dB
Source and Load Impedance 50 Ω
Substrate Material YZ-LiNbO3
Temperature Coefficient of frequency -90 ppm/º C
Notes: 1. All specifications for a device match to a 50 ohm system impedance.
2. Average of the two 3 dB frequency points.
3. All dB values are referenced to the insertion loss.
324 Clark Street, Worcester, MA 01606, USA • Phone 508-852-5400 • Fax 508-852-8456
www.icst.com
QF12/3
140 MHz SAW Bandpass Filter
72 MHz bandwidth
Part Number SF0140BA02393S
Integrated
Circuit
Systems, Inc.
Rev X3 20-Apr-05
Page 2 of 2
Integrated Circuit Systems • Surface Acoustic Wave Products
PACKAGE OUTLINE
Units: mm
Pad Configuration:
Input: 9
Input return: 10
Output: 4
Output Return: 5
Case Ground: All other pins
MATCHING CIRCUIT
9 4
10 5
Typical component values: Ls1 = 94.3 nH Ls2 = 82 nH
(Minimum inductor Q = 40)
Notes
Recommend use of 2% tolerance components. •
• Optimum values depend on board layout. Values intended as guide only.
ISO 9001
Registered
324 Clark Street, Worcester, MA 01606, USA • Phone 508-852-5400 • Fax 508-852-8456
www.icst.com
QF12/3
