Memory Module Specifications KHX16C10B1K2/16X 16GB (8GB 1G x 64-Bit x 2 pcs.) DDR3-1600 CL10 240-Pin DIMM Kit SPECIFICATIONS CL(IDD) 9 cycles Row Cycle Time (tRCmin) 49.5ns (min.) Refresh to Active/Refresh Command Time (tRFCmin) 260ns (min.) Row Active Time (tRASmin) 36ns (min.) Maximum Operating Power 2.460 W* (per module) UL Rating 94 V - 0 Operating Temperature 0o C to 85o C Storage Temperature -55o C to +100o C *Power will vary depending on the SDRAM used. DESCRIPTION FEATURES Kingston's KHX16C10B1K2/16X is a kit of two 1G x 64-bit * * * * * * * * * JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply * * Bi-directional Differential Data Strobe * * On Die Termination using ODT pin * * Asynchronous Reset (8GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM), 2Rx8, memory modules, based on sixteen 512M x 8-bit FBGA components per module. Each module kit supports Intel (R) XMP (Extreme Memory Profiles). Total kit capacity is 16GB. Each module kit has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. The SPD is programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows: XMP TIMING PARAMETERS * * JEDEC: DDR3-1333 CL9-9-9 @1.5V XMP Profile #1: D3-1600 CL10-10-10 @1.5V VDDQ = 1.5V (1.425V ~ 1.575V) 667MHz fCK for 1333Mb/sec/pin 8 independent internal bank Programmable CAS Latency: 9, 8, 7, 6 Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency(CWL) = 7 (DDR3-1333) 8-bit pre-fetch Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm 1%) Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C PCB : Height 1.18" (30.00mm) w/ heatsink, double sided component Continued >> Document No. 48066036-001.A00 11/08/12 Page 1 continued HyperX MODULE DIMENSIONS T E C H N O L O G Y 133.35 Units: millimeters 30.00 18.80 15.80 11.00 8.00 54.70 0.00 0.00 MODULE WITH HEAT SPREADER FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components. Document No. 4806603-001.A00 Page 2