20mm (0.8 INCH ) SINGLE COLOR DOT MATRIX DISPLAY P/N: TA08-81YWA Features YELLOW Description 0.8INCH MATRIX HEIGHT. The Yellow source color devices are made with Gallium DOT SIZE 2mm. Arsenide Phosphide on Gallium Phosphide Yellow Light LOW CURRENT OPERATION. Emitting Diode. COMPATIBLE WITH ASCII AND EBCDIC CODES. STACKABLE VERTICALLY AND HORIZONTALLY. COLUMN ANODE. EASY MOUNTING ON P.C.BOARDS OR SOCKETS. MECHANICALLY RUGGED. STANDARD:GRAY FACE, WHITE DOT. RoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAC9231 REV NO: V.4 DATE: NOV/28/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000063 Selection Guide Part No. Dice TA08-81YWA Iv (ucd) @ 10mA Lens Type YELLOW (GaAsP/GaP) WHITE DIFFUSED Description Min. Typ. 800 3195 Column Anode Electrical / Optical Characteristics at TA=25C Symbol Parameter Device peak Peak Wavelength Yellow D Dominant Wavelength 1/2 Typ. Max. Units Test Conditions 590 nm IF=20mA Yellow 588 nm IF=20mA Spectral Line Half-width Yellow 35 nm IF=20mA C Capacitance Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Yellow 2.1 2.5 V IF=20mA IR Reverse Current Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25C Parameter Yellow Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating / Storage Temperature -40C To +85C Lead Solder Temperature [2] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. SPEC NO: DSAC9231 REV NO: V.4 DATE: NOV/28/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000063 Yellow TA08-81YWA SPEC NO: DSAC9231 REV NO: V.4 DATE: NOV/28/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000063 PACKING & LABEL SPECIFICATIONS TA08-81YWA Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity/ luminous flux or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity/ Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAC9231 REV NO: V.4 DATE: NOV/28/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000063