Memory Module Specifications KVR16N11S6/2 2GB 1Rx16 256M x 64-Bit PC3-12800 CL11 240-Pin DIMM DESCRIPTION SPECIFICATIONS This document describes ValueRAM's 256M x 64-bit (2GB) CL(IDD) 11 cycles DDR3-1600 CL11 SDRAM (Synchronous DRAM) 1Rx16, Row Cycle Time (tRCmin) 48.125ns (min.) memory module, based on four 256M x 16-bit FBGA compo- Refresh to Active/Refresh Command Time (tRFCmin) 260ns (min.) nents. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM Row Active Time (tRASmin) 35ns (min.) uses gold contact fingers. The electrical and mechanical Maximum Operating Power 1.170 W* specifications are as follows: UL Rating 94 V - 0 Operating Temperature 0o C to 85o C FEATURES Storage Temperature -55o C to +100o C * JEDEC standard 1.5V (1.425V ~1.575V) Power Supply *Power will vary depending on the SDRAM used. * VDDQ = 1.5V (1.425V ~ 1.575V) * 800MHz fCK for 1600Mb/sec/pin * 8 independent internal bank * Programmable CAS Latency: 11, 10, 9, 8, 7, 6 * Programmable Additive Latency: 0, CL - 2, or CL - 1 clock * 8-bit pre-fetch * Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] * Bi-directional Differential Data Strobe * Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm 1%) * On Die Termination using ODT pin * Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C * Asynchronous Reset * PCB : Height 1.180" (30.00mm), single sided component Continued >> Document No. VALUERAM1368-001.A00 11/12/13 Page 1 MODULE DIMENSIONS: 133.35 Units: millimeters 30.00 0.15 0.15 8.00 0.15 0.00 0.15 54.70 11.00 0.15 18.80 0.15 0.00 15.80 0.15 Document No. VALUERAM1368-001.A00 Page 2