CY3210-PSOCEVAL1 EVALUATION KIT QUICK START GUIDE 1 2 Insert the CY3210-PSoCEVAL1 kit DVD into the DVD drive of your PC. Remove the CY3210-PSoCEVAL1 board from its package. Install the kit contents, PSoC Designer, and PSoC Programmer. Place the character LCD provided with the kit on J9. Connect jumper (shunt) at JP1 and JP2. Connect the single strand jumper wire between P01 and VR. 3 4 Plug in the MiniProg to the ISSP header on the CY3210-PSoCEVAL1 board. Open PSoC Programmer; click on the Toggle Power button to power the board. Connect the MiniProg to the PC using the USB cable provided with the kit. Vary the potentiometer; the voltage is measured by an ADC and is displayed in hex format on the LCD module. CY3210-PSOCEVAL1 EVALUATION KIT QUICK START GUIDE CY3210-PSoCEVAL1 Evaluation Kit Details RS-232 Transceiver Power LED UART Rx Pin RS-232 Interface Character LCD Interface Prototyping Area UART Tx Pin Voltage Regulator Jumper (JP3) to select Power Option (3.3 V/5 V) DC Supply Jack 9-V Battery Terminals LCD Contrast Control Reset Switch Push Button Switch LEDs Potentiometer (Analog Input) Chip Socket for PSoC Device GPIO Expansion Port ISSP Programming Header JP1 connects P16 to UART Rx Pin JP2 connects P27 to UART Tx Pin For the latest information about this kit, visit http://www.cypress.com/go/CY3210-PSoCEVAL1 (c) 2011-2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc.#: 001-66719 Rev. *C Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Cypress Semiconductor: CY3210-PSOCEVAL1