GaAs MMIC Power Amplifier AM304031MM-QM DATASHEET Preliminary, June 2001 This document contains information on a product under development. The parametric information contains target parameters that are subject to change. DESCRIPTION AMCOM'' s AM304031MM-QM is part of the GaAs MMIC power amplifier series. It has 33dB small signal gain and 31dBm output power over the 3.0 to 4.0 GHz band. This series is in a plastic package with both RF and DC leads at the bottom level of the package to facilitate low-cost SMT assembly to the PC board. This MMIC works over a broad range of DC bias condition to suit various system operating conditions, with Vd ranges from 5V to 7V and Id ranges from 400mA to 700mA. FEATURES APPLICATIONS Y Wide bandwidth from 3 to 4 GHz Y Wireless Internet Access Y High output power, P1dB = 31dBm Y Wireless Local Loop Y High gain, 33dB Y Two way radio Y Fully matched. 50-ohm input/output impedance ABSOLUTE MAXIMUM RATING Parameter Symbol Rating Drain source voltage Vds 8V Gate source voltage Vgs -5V Drain source current Ids 1,200mA Continuous dissipation Pt 7W Tch 200C Channel temperature PERFORMANCE (T A = 25 C) Parameters Vds=7V, Ids=700mA Vds=7V, Ids=600mA Minimum Typical Minimum Typical 3.2 - 3.8 3.0 - 4.2 3.2 - 3.8 3.0 - 4.2 30dBm 31dBm 28.5dBm 29.5dBm Gain (Small signal) 31dB 33dB 31dB 33dB Efficiency 20% 25% 17% 22% 39dBm 40dBm 37dBm 38dBm Frequency (GHz) P1dB IP3 Thermal Resistance e-mail: products@amcomusa.com www.amcomusa.com 8.1 C/W Tel. (301) 353-8400 Fax. (301) 353-8401 P.O.Box 179, 22300 Comsat Drive, Clarksburg, MD 20871 USA AM304031MM-QM DATASHEET Preliminary, June 2001 PERFORMANCE (Ids=500mA and Ids=400mA, T A = 25C) Vds=7V, Ids=500mA Parameters Vds=7V, Ids=400mA Minimum Minimum Minimum Typical 3.2 - 3.8 3.0 - 4.2 3.2 - 3.8 3.0 - 4.2 27dBm 28dBm 25dBm 27dBm Gain (Small signal) 31dB 33dB 31dB 33dB Efficiency 15% 20% 12% 18% 34dBm 37dBm 32dBm 36dBm Frequency (GHz) P1dB IP3 8.1 C/W Thermal Resistance Package Outline 14 13 12 Pin1 2 3 11 AMCOM AMCMMIC 4 10 9 8 5 6 7 Top size Pin Assignment: 1: GND 3: GND 5: Vgg1 7: Vgg3 9: RF Out 11: GND 13: Vdd2 2: RF In 4: GND 6: Vgg2 8: GND 10: GND 12: Vdd3 14: Vdd1 e-mail: products@amcomusa.com www.amcomusa.com Bottom size Notes: 1. Tolerance 0.04mm (1.5mil) unless otherwise specified. 2. Warpage: 0.04mm 3. All dimensions in mm. Tel. (301) 353-8400 Fax. (301) 353-8401 P.O.Box 179, 22300 Comsat Drive, Clarksburg, MD 20871 USA