2087-6001-13 - M/A-COM Technology Solutions, Inc.

• North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400

• India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588

Visit www.macomtech.com for additional data sheets and prod uct information.

M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make

changes to the product(s) or information contained herein without notice.

Point Contact Detector

10 MHz to 18 GHz

Rev. V5

2087-6001-00

ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions

is considering for development. Performance is based on target specifications, simulated results,

and/or prototype measurements. Commitment to develop is not guaranteed.

PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology

Solutions has under development. Performance is based on engineering tests. Specifications are

typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.

Commitment to produce in volume is not guaranteed.

Features

• Broadband Frequency Ranges

• No Bias Required

• Flat Frequency Response

• Passivated Stainless Steel Finish

Specifications

Parameter Specification

Flatness (Maximum) ± 0.75 dB, 10 MHz to 4 GHz

± 1.25 dB, 4 MHz to 8 GHz

± 1.5 dB, 10 MHz to 12 GHz

± 2.5 dB, 10 MHz to 18 GHz

VSWR (Typical) 1.7:1, 10 MHz to 4 GHz

2.7:1, 10 MHz to 8 GHz

3.5:1, 10 MHz to 12 GHz

4.0:1, 10 MHz to 18 GHz

Maximum Power 100 mW

Output Polarity Negative 4

Video Resistance 6 k Ohms Typical 2

Temperature Range -65°C to +100°C

Detector

Part Number Frequency

Range

(GHz) Open Circuit

Voltage

Sensitivity

(mV/mW) Min.

Tangential

Sensitivity

(-dBm) Min.

Output

Capacitance

(pF) Typical

Dimension A

Inches mm

10 MHz to 4 GHz 400 45 12 1.55 39.4

10 MHz to 8 GHz 500 45 12 1.55 39.4

10 MHz to 12 GHz 700 45 12 1.55 39.4

10 MHz to 18 GHz 800 45 12 1.55 39.4

2087-6001-00

1. Usable to 20 GHz

2. For RF power levels below –20 dBm, and with an open circuit load.

3. With video amplifier of 1 MHz bandwidth and 2 dB noise figure.

4. For Positive Output change suffix to -13.

Mechanical Outline Drawing