DESCRIPTION
The Raspberry Pi is a wonderful little computer, but one thing it isn't very good at is controlling
Servo Motors - these motors need very specific and repetitive timing pulses to set the position.
Instead of asking the Pi Linux kernel to send these signals, pop on this handy bonnet! It adds
the capability to control 16 Servos with perfect timing. It can also do PWM up to 1.6 KHz with 12
bit precision, all completely free-running.
For use with Raspberry Pi Model Zero, A+, B+, Pi 2 or Pi 3 (any Pi with 2x20 header) This
bonnet will not fit on an original Raspberry Pi with 2x13 pin header.
The Adafruit 16-Channel 12-bit PWM/Servo Bonnet will drive up to 16 servos or PWM outputs
over I2C with only 2 pins. The on-board PWM controller will drive all 16 channels simultaneously
with no additional Raspberry Pi processing overhead. What's more, you can stack up to 62 of
them to control up to 992 servos - all with the same 2 pins!
Works with any servo that can be powered by 5V and take 3.3V logic level signals. There's a
solder jumper you can adjust if you'd like to change the output logic level to be 5V
Best of all, we even have a Python library you can use, so you'll be up and running instantly, to
make your robotic creation come to life. The Adafruit PWM/Servo Bonnet is the perfect solution
for any project that requires a lot of servos or PWM outputs! Please check out our detailed
Adafruit 16-Channel
PWM / Servo Bonnet
for Raspberry Pi
PRODUCT ID: 3416
71 IN STOCK
Also include 1 x 3x4 Right Angle Male
Header - 4 pack ()
Also include 1 x 5V 2A (2000mA) switching
power supply - UL Listed ()
Also include 1 x 5V 4A (4000mA) switching
power supply - UL Listed ()
Also include 1 x 5V 10A switching power
supply ()
1-9
10-99
100+